Linearity of X-Band Class-F Power Amplifiers in High-Efficiency Transmitters

نویسندگان

  • Manoja D. Weiss
  • Zoya Popović
چکیده

Modern communication signals have time-varying envelopes with significant peak-to-average ratios, resulting in low average efficiency when amplified by commonly used linear power amplifiers (PAs). For linear amplification with increased average efficiency, the Kahn envelope-elimination-and-restoration method uses a highly efficient saturated PA. In this paper, an 8.4-GHz class-F PA with 55% maximum instantaneous efficiency at 610-mW output power, is experimentally characterized in several different biasing modes. Operated in linear mode with constant drain bias, this PA has 10% average efficiency. The suppression of two-tone intermodulation products is 27 dBc when operated at about 0.7 times the peak output power. For the same PA operated in a modified Kahn mode with drive and bias control, a comparable linearity (27.7 dBc) can be obtained at peak output power. Furthermore, the average efficiency increased to 44%, a factor of 4.4 over the linear fixed bias mode.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Class-E Power Amplifiers for Pulsed Transmitters

Nowadays the main driving parameters for the radio transmitter research are: energy efficiency, frequency re-configurability and integration. Pulsed transmitter architectures have attracted large interest in the recent years due to their potential to meet these demands. In pulsed transmitters, a highly efficient switch mode power amplifier (SMPA) is used in conjunction with a pulse modulator to...

متن کامل

A High-Efficiency Transmission-Line GaN HEMT Class E Power Amplifier

In modern wireless communication systems it is required that the power amplifier could operate with high efficiency, high linearity, and low harmonic output level simultaneously. To increase efficiency of the power amplifier, a switching-mode Class E mode technique can be applied. This kind of a power amplifier requires an operation in saturation mode resulting in a poor linearity, and therefor...

متن کامل

Comparison between single band and concurrent multi-band linear power amplifiers

Currently the multiple wireless data transmission technologies have been commercially implemented, such as long-term evolution (LTE), Wi-Fi, and Bluetooth. There is a keen requirement to combine the power amplifiers for those technologies into a single one which can amplifies concurrent multi-band signals. On the physically layer, there are two popular architectures, namely parallel single-band...

متن کامل

Power Amplifiers and Transmitters for RF and Microwave

The generation of RF/microwave power is required not only in wireless communications, but also in applications such as jamming, imaging, RF heating, and miniature dc/dc converters. Each application has its own unique requirements for frequency, bandwidth, load, power, efficiency, linearity, and cost. RF power is generated by a wide variety of techniques, implementations, and active devices. Pow...

متن کامل

Efficient and Wideband Power Amplifiers for Wireless Communications

The rapid evolution of wireless communication systems and the development of new standards require that wireless transmitters process several types of standards across multiple bands. Power amplifiers (PAs) are key components in wireless transmitters because they have a big impact on the overall system performance in terms of their bandwidth, efficiency, and linearity. This thesis presents vari...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001