Applicability Statement for CR - LDP January 2002 2 . Applicability of extensions to LDP
نویسنده
چکیده
As the Internet evolves, additional capabilities are required to ensure proper treatment of data [3], voice, video and other delay sensitive traffic [4]. MPLS enhances source routing and allows for certain techniques, used in circuit switching, in IP networks. This permits a scalable approach to handling these diverse transmission requirements. CR-LDP [1] is a simple, scalable, open, nonproprietary, traffic engineering signaling protocol for MPLS IP networks.
منابع مشابه
RFC 3214 LSP Modification Using CR - LDP
This document presents an approach to modify the bandwidth and possibly other parameters of an established CR-LSP (Constraint-based Routed Label Switched Paths) using CR-LDP (Constraint-based Routed Label Distribution Protocol) without service interruption. After a CR-LSP is set up, its bandwidth reservation may need to be changed by the network operator, due to the new requirements for the tra...
متن کاملImprovement of performance in MPLS domains by using caching and aggregation of CR-LSP
Constraint-based routing (CR-LDP) extends the features of MPLS Label Distribution Protocol (LDP) working in conjunction with a wide variety of QoS scenarios and services including IP differentiated services, integrated services, traffic engineering, Asynchronous Transfer Mode (ATM) service classes and frame relay. When a large number of CR-LSPs are required a lot of CR-LDP signalling is needed:...
متن کاملGeneralized Multi-Protocol Label Switching (GMPLS) Signaling Constraint-based Routed Label Distribution Protocol (CR-LDP) Extensions
Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract This document describes extensio...
متن کاملUsing LDP Multipoint Extensions on Targeted LDP Sessions
Label Distribution Protocol (LDP) can be used to set up Point-to-Multipoint (P2MP) and Multipoint-to-Multipoint (MP2MP) Label Switched Paths. However, the specification for the Multipoint Extensions to LDP presupposes that the two endpoints of an LDP session are directly connected. The LDP base specification allows for the case where the two endpoints of an LDP session are not directly connecte...
متن کاملApplicability Statement for Restart Mechanisms for the Label Distribution Protocol (LDP)
Multiprotocol Label Switching (MPLS) systems are used in core networks where system downtime must be kept to a minimum. Similarly, where MPLS is at the network edges (e.g., in Provider Edge (PE) routers) [RFC2547], system downtime must also be kept to a minimum. Many MPLS Label Switching Routers (LSRs) may, therefore, exploit Fault Tolerant (FT) hardware or software to provide high availability...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2002