RFC 3532 Dynamic Partitioning of Switching
نویسنده
چکیده
This document identifies a set of requirements for the mechanisms used to dynamically reallocate the resources of a switching element (e.g., an ATM switch) to its partitions. These requirements are particularly critical in the case of an operator creating a switch partition and then leasing control of that partition to a third party.
منابع مشابه
Requirements for the Dynamic Partitioning of Switching Elements
This document identifies a set of requirements for the mechanisms used to dynamically reallocate the resources of a switching element (e.g., an ATM switch) to its partitions. These requirements are particularly critical in the case of an operator creating a switch partition and then leasing control of that partition to a third party.
متن کاملOperating Virtual Concatenation (VCAT) and the Link Capacity Adjustment Scheme (LCAS) with Generalized Multi-Protocol Label Switching (GMPLS)
This document describes requirements for, and the use of, the Generalized Multi-Protocol Label Switching (GMPLS) control plane in support of the Virtual Concatenation (VCAT) layer 1 inverse multiplexing data plane mechanism and its companion Link Capacity Adjustment Scheme (LCAS). LCAS can be used for hitless dynamic resizing of the inverse multiplex group. These techniques apply to Optical Tra...
متن کاملDynamic partitioning of link bandwidth in IP/MPLS networks
Bandwidth allocation in the future multiservice global communication IP network presents a very interesting research issue. This paper presents the strategy of Dynamic Partitioning of link bandwidth in IP network. In the Dynamic Partitioning scheme the bandwidth of each link in the network is partitioned into two fractions, one for the low-priority data traffic, and one for the high-priority st...
متن کاملAdaptive Fuzzy Dynamic Sliding Mode Control of Nonlinear Systems
Two phenomena can produce chattering: switching of input control signal and the large amplitude of this switching (switching gain). To remove the switching of input control signal, dynamic sliding mode control (DSMC) is used. In DSMC switching is removed due to the integrator which is placed before the plant. However, in DSMC the augmented system (system plus the integrator) is one dimension bi...
متن کاملMultiprotocol Label Switching (MPLS) Label Switching Router (LSR) Management Information Base (MIB)
This memo defines an portion of the Management Information Base (MIB) for use with network management protocols in the Internet community. In particular, it describes managed objects to configure and/or monitor a Multiprotocol Label Switching (MPLS) Label Switching Router (LSR). Srinivasan, et al. Standards Track [Page 1] RFC 3813 MPLS LSR MIB June 2004
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2003