Adaptive control of grip force to compensate for static and dynamic torques during object manipulation.

Manipulating a cup by the handle requires compensating for the torque induced by the moment of the mass of the cup relative to the location of the handle. In the present study, we investigated the control strategy of subjects asked to perform grip-lift movements with an object with center of mass located away from the grip axis. Participants were asked to lift the manipulandum with a two-fingers precision grip and stabilize it in front of a visual target. Subjects showed a gradual and slow adaptation of the grip-force scaling across trials: the grip force tended to decrease slowly, and the temporal coordination between grip-force and load-torque rates displayed gradually, better-coordinated patterns. Importantly, this adaptation was much slower than the stabilization of the same parameters measured either when no torque came into play or after previous adaptation to the presence of a torque. In contrast, the maximum rotation induced by the torque was controlled efficiently after only few trials, and an unexpected decrease in the tangential torque produced significant overcompensation. An unexpected increase in torque produced a consistent opposite effect. This shows that the compensation for the dynamic torque was based on an anticipatory, dynamic counter-torque produced by the arm and wrist motor commands. The comparatively slow stabilization of grip-force control suggests a specific adaptation process engaged by the presence of the torque. This paradigm, including tangential torques, clearly constitutes a powerful tool to extract the adaptive component of grip control during object manipulation.