Global trajectory planning for fault tolerant manipulators
نویسندگان
چکیده
Whether a task can be completed after a failure of one of the degrees-of-freedom of a redundant manipulator depends on the joint angle at which the failure takes place. It is possible to achieve fault tolerance by globally planning a trajectory that avoids unfavorable joint positions before a failure occurs. In this paper, we present a trajectory planning algorithm that guarantees fault tolerance while simultaneously satisfying joint limit and obstacle avoidance requirements.
منابع مشابه
Optimal Control of Underactuated Manipulators via Actuation Redundancy
The increased utilization of manipulators in hazardous or hard-to-reach environments have led to a corresponding increase on the study of fault tolerant control methods for these mechanisms, ranging from robot design and trajectory planning to fault detection and isolation and post-failure control algorithms. In this article we focus on post-failure control of a mechanical manipulator from the ...
متن کاملFault-Tolerant Kinematic Controller Design for Underactuated Robot Manipulators
The trajectory generation problem for fault-tolerant robot manipulators is considered. A new technique which extends the Inverse Kinematics optimization approach to the case of robots with actuator faults is proposed. A bound on the second-order non-integrable constraints resulting from underactuation is assumed, and the trajectory generation problem is formulated as a nonlinear time-varying st...
متن کاملFault Tolerant Task Execution through Global Trajectory Planning
Whether a task can be completed after a failure of one of the degrees-of-freedom of a redundant manipulator depends on the joint angle at which the failure takes place. It is possible to achieve fault tolerance by globally planning a trajectory that avoids unfavorable joint positions before a failure occurs. In this article, we present a trajectory planning algorithm that guarantees fault toler...
متن کاملPlanning and Control of Two-Link Rigid Flexible Manipulators in Dynamic Object Manipulation Missions
This research focuses on proposing an optimal trajectory planning and control method of two link rigid-flexible manipulators (TLRFM) for Dynamic Object Manipulation (DOM) missions. For the first time, achievement of DOM task using a rotating one flexible link robot was taken into account in [20]. The authors do not aim to contribute on either trajectory tracking or vibration control of the End-...
متن کاملDesigning Fault-Tolerant Manipulators: How Many Degrees-of-Freedom?
One of the most important parameters to consider when designing a manipulator is the number of degrees-of-freedom (DOFs). This article focuses on the question: How many DOFs are necessary and sufficient for fault tolerance and how should these DOFs be distributed along the length of the manipulator? A manipulator is fault tolerant if it can complete its task even when one of its joints fails an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1995