Broadly tunable, low timing jitter, high repetition rate optoelectronic comb generator.
نویسندگان
چکیده
We investigate the low timing jitter properties of a tunable single-pass optoelectronic frequency comb generator. The scheme is flexible in that both the repetition rate and center frequency can be continuously tuned. When operated with 10 GHz comb spacing, the integrated residual pulse-to-pulse timing jitter is 11.35 fs (1 Hz to 10 MHz) with no feedback stabilization. The corresponding phase noise at 1 Hz offset from the photodetected 10 GHz carrier is -100 dBc/Hz.
منابع مشابه
All-fibre photonic signal generator for attosecond timing and ultralow-noise microwave.
High-impact frequency comb applications that are critically dependent on precise pulse timing (i.e., repetition rate) have recently emerged and include the synchronization of X-ray free-electron lasers, photonic analogue-to-digital conversion and photonic radar systems. These applications have used attosecond-level timing jitter of free-running mode-locked lasers on a fast time scale within ~10...
متن کاملUltralow-repetition-rate pulses with ultralow jitter generated by passive mode-locking of an optoelectronic oscillator
We demonstrate the generation of an ultralow-repetition-rate pulse train with a repetition rate of 19.6 kHz by passive mode-locking of an optoelectronic oscillator. The pulse-to-pulse timing jitter equals 0.06 ppm of the repetition time of the pulses. No significant dependence of pulse duration, pulse waveform, and timing jitter was observed when the cavity length was changed from 150 to 10,400...
متن کاملToward a low-jitter 10 GHz pulsed source with an optical frequency comb generator.
We demonstrate low residual timing jitter of 10 GHz pulses from a 1.55 ?m optical frequency comb generator based on a doubly-resonant electro-optic modulator. The comb spectral phase is shown to be linear but of different slopes for the two sides of the optical spectrum. The linear phase delay predicts well the measured timing delay of the two pulse trains from the comb generator. The pulse tim...
متن کاملLow-noise synthesis of microwave and millimetre-wave signals with optical frequency comb generator
The phase noise of a 20 GHz picosecond optical pulse train generated by a modulator-based optical frequency comb generator is analysed. The residual timing jitter is 10 fs for Fourier frequencies from 10 Hz to 10 MHz. Photodetection of the optical pulse train provides millimetre-wave signals with similarly low residual jitter at 40, 60, and 80 GHz with applicable powers of 27.5, 210.5, and 213 ...
متن کاملSynchronization of 3ghz Repetition Rate Harmonically Mode-locked Fiber Laser for Optical Timing Applications*
We have successfully stabilized a 3GHz Harmonically Mode-Locked fiber ring laser by a PLL feedback control of the cavity length to reduce the pulses RMS timing jitter. The laser cavity is composed of all PM fibers and components to eliminate polarization instabilities and to reduce the vibration sensitivity. The laser stability in terms of timing jitter was around 9ps in the range 10Hz10MHz. Us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Electronics letters
دوره 51 20 شماره
صفحات -
تاریخ انتشار 2015