Modeling and Manufacturing of a Micromachined Magnetic Sensor Using the CMOS Process without Any Post-Process
نویسندگان
چکیده
The modeling and fabrication of a magnetic microsensor based on a magneto-transistor were presented. The magnetic sensor is fabricated by the commercial 0.18 mm complementary metal oxide semiconductor (CMOS) process without any post-process. The finite element method (FEM) software Sentaurus TCAD is utilized to analyze the electrical properties and carriers motion path of the magneto-transistor. A readout circuit is used to amplify the voltage difference of the bases into the output voltage. Experiments show that the sensitivity of the magnetic sensor is 354 mV/T at the supply current of 4 mA.
منابع مشابه
New Method for Analysis of image sensor to produce and evaluate the image
In this paper, a new method for evaluating CMOS image sensors based on computer modeling and analysis is introduced. Image sensors are composed of different parts, each of which has a specific effect on image quality. Circuits of image sensors can be evaluated and analyzed using circuit simulators or theoretically, but these methods cannot help to produce the final image. In order to produce th...
متن کاملModeling of Weld Bead Geometry Using Adaptive Neuro-Fuzzy Inference System (ANFIS) in Additive Manufacturing
Additive Manufacturing describes the technologies that can produce a physical model out of a computer model with a layer-by-layer production process. Additive Manufacturing technologies, as compared to traditional manufacturing methods, have the high capability of manufacturing the complex components using minimum energy and minimum consumption. These technologies have brought about the possibi...
متن کاملA Surface Micromachined CMOS MEMS Humidity Sensor
This paper reports a CMOS MEMS (complementary metal oxide semiconductor micro electromechanical system) piezoresistive humidity sensor fabricated by a surface micromachining process. Both pre-CMOS and post-CMOS technologies were used to fabricate the piezoresistive humidity sensor. Compared with a bulk micromachined humidity sensor, the machining precision and the sizes of the surface micromach...
متن کاملA Post-CMOS Micromachined Lateral Accelerometer
In a post-complementary metal–oxide–semiconductor (CMOS) micromachining technology, the process flow enables the integration of micromechanical structures with conventional CMOS circuits which are low-cost and readily available. This paper presents a lateral capacitive sensing accelerometer fabricated in the post-CMOS process. Design advantages include electrically isolated multimetal routing o...
متن کاملDesign of a Low Power Magnetic Memory in the Presence of Process Variations
With the advancement in technology and shrinkage of transistor sizes, especially in technologies below 90 nm, one of the biggest problems of the conventional CMOS circuits is the high static power consumption due to increased leakage current. Spintronic devices, like magnetic tunnel junction (MTJ), thanks to their low power consumption, non-volatility, compatibility with CMOS transistors, and t...
متن کامل