Fracture Parameters for Cracked Cylincal Shells

Thermoelastic Fracture Parameters for Anisotropic Plates

This paper deals with the determination of the effect of varying material properties on the value of the stress intensity factors, KI and KII, for anisotropic plates containing cracks and subjected to a temperature change. Problems involving cracks and body forces, as well as thermal loads are analysed. The quadratic isoperimetric element formulation is utilized, and SIFs may be directly obtain...

Fracture Behavior Prediction for Rapidly Loaded Surface Cracked Specimens

The feasibility of predicting the fracture behavior of surface cracks from shallow cracked bend specimens was investigated. The material studied was a high-strength steel stress relief embrittled to various levels of Charpy-V notch impact toughness. Material toughness was quantified in terms of the J-intergral at total specimen failure (-/„,,), using both deeply notched and shallow-notched bend...

Fracture penetration in planetary ice shells

The cracked tooth syndrome--crown root vertical fracture.

A case of an incomplete tooth fracture followed by a complete fracture was presented. The difficulty of diagnosing this condition was discussed as well as the possible histological explanation of the symptoms experienced by the patient. It once again points out to practising dentists, that whilst deep pockets can give rise to severe periodontal pain, intense and excruciating pain should be inve...

The Nonlinear Response of Cracked Aluminum Shells Subjected to Combined Loads

The results of a numerical study of the nonlinear response of thin unstiffened aluminum cylindrical shells with a longitudinal crack are presented. The shells are analyzed with a nonlinear shell analysis code that accurately accounts for global and structural response phenomena. The effects of initial crack length on the prebuckling, buckling and postbuckling responses of a typical shell subjec...

Buckling of cracked cylindrical thin shells under combined internal pressure and axial compression

Linear eigenvalue analysis of cracked cylindrical shells under combined internal pressure and axial compression is carried out to study the effect of crack type, size and orientation on the buckling behavior of cylindrical thin shells. Two types of crack are considered; through crack and thumbnail crack. Our calculations indicate that depending on the crack type, length, orientation and the int...