Modeling of carbon monoxide dispersion around the urban tunnel portals

نویسندگان

  • M. Rafiei Department of Mechanical Engineering, Semnan Branch, Islamic Azad University, Semnan, Iran|Institute of Internal Combustion Engines and Thermodynamics – IVT, Graz University of Technology, Austria.
  • P.J. Sturm Institute of Internal Combustion Engines and Thermodynamics – IVT, Graz University of Technology, Austria.
چکیده مقاله:

The aim of this study is to investigate the problems caused by discharge of polluted air from tunnels into the environment with a specific focus on residential areas. In city tunnels, portal or stacks, pollutant management is a big challenge. Nowadays, air quality management, particularly in urban tunnels, is considered as a part of the ventilation system design. The goal is to see the environmental impacts beforehand. From environmental aspects, preventive measures are required either inside or outside the tunnel in some cases. Niayesh tunnel in Tehran is taken as a case for proving the objectives presented in this study. Concentration of carbon monoxide at the vicinity of the portals is calculated using the proper dispersion simulation. The results of dispersion modeling for the assumed worst case of ventilation can help to understand the environmental impact of ventilation. The worst traffic emissions for a congested traffic scenario,are selected as an emission source for dispersion modeling. According to the traffic condition and fleet composition, the crucial emission extracted from the tunnel is carbon monoxide. Therefore, the performed simulation only focuses on carbon monoxide dispersion modeling. From the other side, carbon monoxide is taken as a demonstration pollutant, because it is inert and chemical reactions can be neglected in short-term considerations. A lagrangian model composed of Graz Lagrangian Model and Graz Mesoscale Model is used for flow-field and dispersion calculations.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An assessment on dispersion of carbon monoxide from acement factory

Background: Modeling the dispersion of pollutants from factory stacks addresses the problem of matching emissions of a cement plant with the capacity of the environment to avoid affecting the environment and society. The main objective of this study was to simulate the dispersion of carbon monoxide (CO) from the main stack of a cement plant in Doroud, Iran using SCREEN3 software developed by th...

متن کامل

QT dispersion in carbon monoxide poisoning.

BACKGROUND Carbon monoxide (CO) poisoning are serious health problems, and effect of reducing the blood's oxygen carrying capacity. Deaths due to CO poisoning are mostly related to myocardial injury and central nervous system pathologies. AIM The objective of this study was to determine the relationship between carbon monoxide intoxication, QT dispersion, and cardiac markers. MATERIALS AND ...

متن کامل

Carbon monoxide poisoning increases Tpeak–Tend dispersion and QTc dispersion

OBJECTIVES Carbon monoxide (CO) poisoning leads to cardiac dysrhythmia. Increased heterogeneity in ventricular repolarisation on electrocardiogram (ECG) shows an increased risk of arrhythmia. A number of parameters are used to evaluate ventricular repolarisation heterogeneity on ECG. The aim of our study is to investigate the effect of acute CO poisoning on indirect parameters of ventricular re...

متن کامل

Modeling flow around bluff bodies and predicting urban dispersion using large eddy simulation.

Modeling air pollutant transport and dispersion in urban environments is especially challenging due to complex ground topography. In this study, we describe a large eddy simulation (LES) tool including a new dynamic subgrid closure and boundary treatment to model urban dispersion problems. The numerical model is developed, validated, and extended to a realistic urban layout. In such application...

متن کامل

Modeling Flow around Bluff Bodies and Predicting Urban Dispersion Using Large Eddy Simulation

Y U H E N G T S E N G , † , § C H A R L E S M E N E V E A U , † A N D M A R C B . P A R L A N G E * , ‡ Department of Mechanical Engineering, Center for Environmental and Applied Fluid Mechanics, and Department of Geography and Environmental Engineering, The Johns Hopkins University, 3400 North Charles Street, Baltimore, Maryland 21218, and School of Architecture, Civil and Environmental Engine...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 4  شماره 3

صفحات  359- 372

تاریخ انتشار 2018-07-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023