Standing Handball Throwing Velocity Estimation with a Single Wrist-Mounted Inertial Sensor

نویسندگان

  • Celal Gençoğlu Department of Physical Education and Sport Teacher, Faculty of Sport Sciences, Dokuz Eylül University, Turkey
  • Hikmet Gümüş Department of Coaching Education, Faculty of Sport Sciences, Dokuz Eylül University, Turkey
چکیده مقاله:

Background. It is well known that overarm throwing is one of the most performed activities in the handball. Shoulder and glenohumeral injuries incidence are high in handball because of both pass, and shooting activity was executed repeatedly in high angular speed. Objectives. This study set out to investigate the usefulness of inexpensive commercial inertial movement sensors for prediction of throwing velocity in handball. Methods. After the IMU sensor (500 Hz) placed to the wrist of the dominant arm, players (n=4; 24.4 ±1.4 years, 181.75 ±11 cm height, 84.58 ±16 kg weight) performed 30 standing overarm throwings from a seven-meter distance with 1-minute rest between trials. Throwing velocity compared between radar speed gun and estimations of accelerometer data. Recorded acceleration data filtered (Butterworth 20 Hz 2nd order) than the acceleration vector magnitude calculated. Each throwing data aligned such as 125 data points of before and after the peak acceleration (250ms). Performance metrics of prediction models (Generalized Linear Model, Gradient Boosted Trees, and Support Vector Machine) calculated with root mean square, absolute error, and correlation coefficient parameters. Results. There were reasonably small absolute errors and root mean square values of the machine learning models. Also, there was a very high correlation between measured and predicted velocities with all three models. Conclusion. This is the first study to examined machine learning models to predict handball throwing velocity using a high-frequency triaxial accelerometer. The finding of the present study revealed that the wrist-attached accelerometer precisely estimates the throwing velocity in handball. Further research is required to quantifying the overarm activities in handball, which included block, defensive contact, passing, or shooting. Therefore the accelerometer-based collected data may provide detection of movement in game-play automatically so that the upper extremity load of players can be monitored and avoid the possible overuse injury risk.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Throwing Velocity in Male Handball Players

Chelly, MS, Hermassi, S, and Shephard, RJ. Relationships between power and strength of the upper and lower limb muscles and throwing velocity in male handball players. J Strength Cond Res 24(6): 1480–1487, 2010—This study aimed to investigate relationships between peak power (PP) as measured by upper limb (PPUL) and lower limb (PPLL) force– velocity tests, maximal upper limb force assessed by 1...

متن کامل

Effect of Core Training on Male Handball Players’ Throwing Velocity

In handball, throwing velocity is considered to be one of the essential factors in achieving the ultimate aim of scoring a goal. The objective of the present study was to analyze the effect of a core training program on throwing velocity in 30 handball players (age 18.7 ± 3.4 years, body height 179.3 ± 7.0 cm, body mass 78.9 ± 7.7 kg), 16 of whom were in the junior category and 14 of whom were ...

متن کامل

Relationship between throwing velocity, muscle power, and bar velocity during bench press in elite handball players.

PURPOSE The purpose of this study was to examine the relationship between ball-throwing velocity during a 3-step running throw and dynamic strength, power, and bar velocity during a concentric-only bench-press exercise in team-handball players. METHODS Fourteen elite senior male team-handball players volunteered to participate. Each volunteer had power and bar velocity measured during a conce...

متن کامل

Slope Estimation during Normal Walking Using a Shank-Mounted Inertial Sensor

In this paper we propose an approach for the estimation of the slope of the walking surface during normal walking using a body-worn sensor composed of a biaxial accelerometer and a uniaxial gyroscope attached to the shank. It builds upon a state of the art technique that was successfully used to estimate the walking velocity from walking stride data, but did not work when used to estimate the s...

متن کامل

Walking speed estimation using a shank-mounted inertial measurement unit.

We studied the feasibility of estimating walking speed using a shank-mounted inertial measurement unit. Our approach took advantage of the inverted pendulum-like behavior of the stance leg during walking to identify a new method for dividing up walking into individual stride cycles and estimating the initial conditions for the direct integration of the accelerometer and gyroscope signals. To te...

متن کامل

Pedestrian Navigation Using Foot-Mounted Inertial Sensor and LIDAR

Foot-mounted inertial sensors can be used for indoor pedestrian navigation. In this paper, to improve the accuracy of pedestrian location, we propose a method using a distance sensor (LIDAR) in addition to an inertial measurement unit (IMU). The distance sensor is a time of flight range finder with 30 m measurement range (at 33.33 Hz). Using a distance sensor, walls on corridors are automatical...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 8  شماره 3

صفحات  0- 0

تاریخ انتشار 2020-10

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

کلمات کلیدی

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023