Dissimilar joint with good quality and mechanical properties is one of the major problems the industries. One of the most commonly used methods to solve this problem is friction stir welding process. In this paper two different tool pin with simple cylindrical and screwed profile were used to finding optimization of friction stir welding parameters to reach best mixing flow, composite structure...

the previous studies show that a high percentage of traffic accidents take place in two-lane rural highways and most of which happen at horizontal curves. meanwhile the horizontal alignment is often subject to hard topographic conditions where because of economic aspects designers are forced to design horizontal curves at grades. vertical angle of longitudinal slope reduces the normal force of ...

in this work, experimental studies of internal friction coefficient and porosity of four high productive rice varieties in iran (nemat, neda, pajouhesh and pardis) have been presented. moisture content varied in four different ranges between 8 and 20%. the obtained results indicated that the internal friction coefficient decreased with increasing the moisture content from 8 to 11%, then decreas...

To accommodate major civil engineering projects in or in the vicinity of peatlands, it is essential to stabilise peat deposits. On the other hand, the accumulation of waste tyres in recent decades has caused environmental problems around the world. An effective remedy for both issues is to use scrap tyre material to stabilise problematic peat soils. This article reports an experimental investig...

Based on an actual corrugated steel plate arch bridge, considering soil-structure interaction, by using the finite element program of ANSYS, a 2-D finite element model was set up to analyze the soil pressure and structural deformation under different load conditions in detail. Since this type of structure relies on the soil-structure interaction to share the load, as the structural parameters h...

Injecting water into a coal seam to enhance the cohesive strength of coal and thus minimize and reduce the coal wall spalling risk must be considered in underground coal mining systems. In general, coal with low cohesive strength contains clay minerals which may affect the stability of coal by interacting with water. Therefore, the coupled effects of moisture content and inherent clay minerals ...