A quasi-continuum (QC) method based on the embedded atom method (EAM) potential was employed to investigate the fatigue crack growth and expansion characteristics of single-crystal Fe and Ni under cyclic loading modes I and II. In particular, the crack growth and expansion characteristics of Fe and Ni under cyclic loading were evaluated in terms of atomic stress fields and force–distance curves...

Application of surface modification methods is expected to be a supreme solution to diminishing fretting damage. In this study, our aim was to improve the fretting fatigue life of Al7075-T6 alloy by covering it with a TiN thin film hard coating using the magnetron sputtering technique. Coated specimens with the best surface hardness, adhesion strength and roughness were tested with a rotating b...

The present paper examines crack growth in a range of aerospace and automotive structural adhesive joints under cyclic-fatigue loadings. It is shown that cyclic-fatigue crack growth in such materials can be represented by a form of the Hartman–Schijve crackgrowth equation, which aims to give a unique and linear ‘master’ representation for the fatigue data points that have been experimentally ob...

In this research, the influence of bolt preload on the fatigue strength of 2024-T3 aluminium alloy double lap bolted joints has been studied experimentally and numerically. To do so, three sets of the specimens were prepared and each of them subjected to tightening torque of 1,2.5 and 5 N-m and then fatigue tests were conducted under various cyclic axial load levels. In the numerical method, th...

the crankshaft is one of the most critically loaded components as it experiences cyclic loads in the form of bending and torsion during its service life. its failure will cause serious damage to the engine so it’s important at the time of design to verify fatigue strength. more challenges in crankshaft design due to increasing vehicle payloads, lower weight requirement, higher efficiency and lo...

When subjected to alternating stresses, most materials degrade, e.g., suffer premature failure, due to a phenomenon known as fatigue. It is generally accepted that in brittle materials, such as ceramics, cyclic fatigue can only take place where there is some degree of toughening, implying that premature fatigue failure would not be expected in polycrystalline silicon where such toughening is ab...

Room temperature monotonic and cyclic stress–strain curves for single crystal and polycrystalline NiTi shape memory alloys containing Ti3Ni4 precipitates are presented. The tensile and compressive single crystal results illustrate the importance of crystallographic texture, the unidirectional nature of the martensitic transformation, and martensite detwinning on tension-compression stress–strai...

In this research, the effects of notch shape on the fatigue strength of 2024-T3 aluminum alloy notched specimens have been studied using experimental and multiaxial fatigue analysis. For this purpose, four set of specimens with different notch shape were prepared and then fatigue tests were carried out at various cyclic longitudinal load levels. Load controlled fatigue tests of mentioned specim...