We have developed a large-aperture, flash-lamp-pumped Cr:LiSrAlF(6) (Cr:LiSAF) amplifier for use in a femtosecond chirped-pulse amplifier system. Optimum design of the 19-mm-diameter amplifier results in a single-pass gain of 5 with good beam quality. This amplifier produces 1.05-J pulses after compression, with a width of 125 fs at a repetition rate of 0.05 Hz.

Recently, the rising the demand of Darlington products for the high data rate communication system. Darlington transistors are used in applications where a high gain is needed at a low frequency. Recently Darlington cell and Darlington topology have been reported high gain and good bandwidth for modern application. In modern communication Darlington amplifier is versatile used in low noise ampl...

In this paper, a low noise high gain CMOS amplifier for minute nerve signals is presented. By using a mixture of weakand strong inversion transistors, optimal noise suppression in the amplifier is achieved. A continuous-time offsetcompensation technique is utilized in order to minimize impact on the amplifier input nodes. The method for signal recovery from noisy nerve signals is presented. A p...

A large dynamic-range Variable Gain Amplifier (VGA) suitable for Ultra Wide Band (UWB) applications is presented. The VGA is composed of three programmable variable gain amplifier stages followed by an output buffer. Such wide bandwidth allows our proposed VGA to be used in multi-standard protocols. Power reduction is developed for the variable gain amplifier stages. Thorough analyses of the mi...

in this paper a wideband single stage pseudomorphic high electron mobility transistor (PHMET) amplifier has been designed at 5.8 GHz, the input and output matching circuits have a pi form.Noise cancelling principle and sensitivity analysis are performed .Simulation results have been compared with their correspondence in [10] give 2.71 dB improvement in amplifier gain at the same noise figure (N...

A 2 GHz programmable-gain amplifier (PGA) using 0.12-μm CMOS technology is presented in this paper, which has a 51 dB gain control range with 3 dB gain control steps. The maximum output power of this PGA achieves 9 dBm while the 1-dB compression point is located at 8 dBm. A high linearity denoted by the oIP3 of 22 dBm at the maximum gain has been achieved. A new configuration to digitally imple...

This Paper presents the design of a wideband variable gain amplifier (VGA) using 0.18 μm standard CMOS technology. The proposed VGA realizes wideband flat gain using wideband flat negative capacitance. It achieves a 3 dB gain bandwidth of 1 GHz with a maximum gain of 23 dB. Also, it shows P1 dB of −33 to −6 dBm over the gain range of −28 to 23 dB. The overall current consumption is 5.5 mA under...

The DC open-loop voltage Gain is a very important specification for amplifiers. In order to increase this specification, in this paper, we have proposed an improved folded cascode gain boosted amplifier (improved FCGBA) which has extremely large DC open-loop voltage gain. Compared to traditional FCGBA, this novel structure needs only one auxiliary amplifier, so it is energy saving. Finally, wit...

Abstract. We use an analytic approach to study the susceptibility of the P Low Frequency Instrument radiometers to various systematic effects. We examine the effects of fluctuations in amplifier gain, in amplifier noise temperature and in the reference load temperature. We also study the effect of imperfect gain modulation, non-ideal matching of radiometer parameters, imperfect isolation i...

Wired CDMA interface with adaptivity for interconnect capacitances is designed to receive transmitted data even under a wide variety of connection topologies. The variable gain amplifier (VGA) is one of key circuit blocks to realize the adaptivity for interconnect capacitances. The system level numerical simulations derive the VGA specifications that the required VGA gain range is from 0.37 to ...