A bidirectional converter (BDC) is required in areas where generated energy is stored. Some of the application areas are uninterruptible power system, transportation,, flywheel energy storage systems, etc. Bidirectional flow of power using buck mode and boost mode along with efficiency and high power density is important need of such systems. This report proposes a new topology of BDC with the ...

The operation of a battery power bank with series-connected buck–boost-type battery power modules (BPMs) was investigated in this study. Each BPM consisted of a battery pack with an associated buck–boost converter for individually controlling battery currents. With a proposed discharging scenario, load voltage regulation with charge equalization among batteries was performed by controlling the ...

In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...

This chapter deals with the design methodologies to obtain DC-DC converters with multiple outputs and only one inductor. The four possible schemes, buck, boost, and inverting or noninverting buck-boost, are considered. The key specific problems related to the issue are the inductor current switching scheme, the multiple-loops control, the suitable driving of power switches and, accordingly, the...

Passivity{based feedback controllers are derived for the indirect stabilization of the average output voltage in Pulse{Width{Modulation (PWM) controlled dc{to{dc power converters of the \boost", \buck{boost" and \buck" types. The controller design is carried out on the basis of well known average PWM models of such circuits. These models are shown to be Euler{Lagrange systems corresponding to a...

A new resonant switch is introduced which employs nonlinear tank elements. Zero current switching is obtained. yet the peak transistor voltage and current stresses can approach those of an equivalent ideal PWM converter. Reduced switching loss without a substantial increase in conductbn loss is therefore possible. An approximate analysis is outlined, and transistorpeak voltage and current stres...

Analytical spectral modeling of switched-mode PWM converters, operating in the discontinuous conduction mode, is presented. The modeling approach is to derive analytical expressions of the converter output response using the extended Volterra functional series. Nonlinear frequency responses, including additional DC offset as well as significant subharmonic and higher harmonic components, due to...

This paper presents a wide range maximum power point tracker (MPPT) using fuzzy logic controller for PV sizing and efficiency improvement. The MPPT consists of a buck boost converter, controlled by a fuzzy logic. The fuzzy has two inputs and single output. Inputs are voltage and current of the PV, while the output is duty cycle for the buck boost. The MPPT effectively tracks at average 97.3% of...

The duality principle is applied to derive new single-stage power-factor-correction (PFC) voltage regulators. This paper begins with an application of duality transformation to conventional discontinuousconduction-mode buck, buck-boost and boost converters. The resulting dual converters operate in the discontinuous capacitor voltage mode. These new converters provide the same PFC property, but ...