An S-band gain-clamped erbium-doped fiber amplifier module, employing a fiber Bragg grating to serve as a reflected element for lasing a saturated tone injected into the module by forward optical feedback method, is proposed and investigated experimentally. Moreover, the performance and behavior of the gain and noise figure in the proposed gain-clamped S-band fiber amplifier have also been disc...

A novel class-AB transconductance amplifier, suitable for the input stage of high slew rate CMOS operational amplifier is proposed. The proposed class-AB transconductor is realized from a differential pair of mixed translinear common-drain push-pull circuit. A high speed operational amplifier employing the proposed input stage and a complementary common –source high gain stage is presented. HSP...

We model the non-linear gain characteristics of a Fabry-Perot semiconductor optical amplifier using a modified photon density rate equation. Good agreement is found with experimental results, with the simulation accurately reproducing all the major characteristics of the amplifier. To our knowledge, this is the first calculation using only the rate equations that accurately predicts the gain an...

Recent theoretical work predicts that the quantum-limited noise figure of a x(3)-based fiber-optical parametric amplifier operating as a phase-insensitive in-line amplifier or as a wavelength converter exceeds the standard 3-dB limit at high gain. The degradation of the noise figure is caused by the excess noise added by the unavoidable Raman gain and loss occurring at the signal and the conver...

We show analytically that tailoring the fiber dispersion appropriately can cause optical solitons to propagate unperturbed, without emission of dispersive waves, in a distributed-gain fiber amplifier with a nonuniform gain profile. We apply our scheme to a bidirectionally pumped fiber amplifier and discuss the importance of higher-order nonlinear and dispersive effects for short solitons.

At the University of Rochester we have constructed and tested a large-aperture, (1.0 x 6.5 cm), high-gain (8) Brewster 's angle zigzag Nd:glass amplifier with a repetition rate of 2 Hz. This amplifier has a gain uniformity of +/-3 % and a maximum stress-induced depolarization <2.5 %.

This work describes the comparison of the amplification characteristics (gain) and the Noise figure (NF) of the Thulium and Erbium in three different host materials which the Yttria Alumina-Silica glass, Fluoride and Tellurite fiber glass. The gain using these host materials covers the range 1.45-1.65 μm. Thulium doped fiber amplifier (TDFAs) operated in the region of wavelength (1480-1510 nm) ...

Wide frequency bandwidth has been internationally allocated for unlicensed operation around the oxygen absorption frequency at 60 GHz. A power amplifier and a low noise amplifier are presented as building blocks for a T/R-unit at this frequency. The fabrication technology was a commercially available 0.15 μm gallium arsenide (GaAs) process featuring pseudomorphic high electron mobility transist...

The bandwidth of a single-pump fiber optical parametric amplifier is governed by the even orders of fiber dispersion at the pump wavelength. The amplifier can exhibit gain over a wide wavelength range when operated near the fiber's zero-dispersion wavelength. It can also be used for broadband wavelength conversion,with gain. We have experimentally obtained gain of 10-18 dB as the signal wavelen...

We successfully fabricate three-mode erbium doped fiber with a confined Er(3+) doped ring structure and experimentally characterize the amplifier performance with a view to mode-division multiplexed (MDM) transmission. The differential modal gain was effectively mitigated by controlling the relative thickness of the ring-doped layer in the active fiber and pump launch conditions. A detailed stu...