Cold rolled sheet metal often used in laser forming exhibits anisotropic properties, which are mostly caused by preferred orientations of grains developed during the severe plastic deformation. In present study, the textures of cold-rolled mild steel sheets are characterized and the influence of the plastic anisotropy on laser forming process is investigated. Deformation textures are measured i...

We show that cantilever array sensors can sense the formation of supported phospholipid bilayers on their surface and that they can monitor changes in mechanical properties of lipid bilayers. Supported lipid bilayers were formed on top of microfabricated cantilevers by vesicle fusion. The formation of bilayers led to a bending of the cantilevers of 70-590 nm comparable to a surface stress of 27...

The mechanical behavior of an ensemble of athermal fibers forming a nonbonded network subjected to triaxial compression is studied using a numerical model. The response exhibits a power law dependence of stress on the dilatation strain and hysteresis upon loading and unloading. A stable hysteresis loop results after the first loading and unloading cycle. In the early stages of compaction, strai...

Families of inextensible fibers forming a surface are considered. Each fiber supports a twisting couple proportional to the torsion of the fiber. The strain energy density is written in an additive form, such that the contributions due to shearing, twisting and bending effects are taken into account separately. The equilibrium equations, here obtained, are a particular case of the ones obtained...

We show that the number of concentric graphene cylinders forming a carbon nanotube can be found by squeezing the tube between an atomic force microscope tip and a silicon substrate. The compressed height of a single-walled nanotube (double-walled nanotube) is approximately two (four) times the interlayer spacing of graphite. Measured compression forces are consistent with the predicted bending ...

The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...

Core yarn was spun by introducing a PVA multifilament as the core through the yarn forming zone of a ring spinning frame and viscose fibers as the sheath containing tracer fibers. The water soluble PVA multifilament was extracted from the yarn structure. Then internal structure and properties of the hollow ring yarn was assessed and compared with those of typical ring yarns. Also, two plain fab...

The "dynamic" or "glass" transition in biomolecules is as important to their functioning as the folding process. This transition occurs in the low temperature regime and has been related to the onset of biochemical activity that is dependent on the hydration level. This protein transition is believed to be triggered by the strong hydrogen bond coupling in the hydration water. We study the vibra...

Although considerable effort has gone into characterizing the laser forming process in terms of process parameters and conditions, there has been little emphasis on the effects of the mechanical and thermal constraints introduced by the clamping method utilized for a desired application. This research suggests means for investigating and predicting the resulting geometry of a specimen due to la...

Accurate prediction of the final shape using numerical modeling has been a top priority in the field of sheet and bulk forming. Better shape prediction is the result of a better estimation of the physical stress and strain state. For experimental and numerical investigations of such estimations, simple benchmark processes are used. In this paper a benchmark process involving forging (flattening...