The present study reveals that the conventional notion that thermal contact resistance increases with porosity does not necessary hold. It is proved through a mechanistic robust model that, under specific circumstances, the porosities of two contacting bodies attain a critical value beyond which the contact resistance counter-intuitively drops. The model focuses on micro porous layers (MPLs) co...

Using single-displacement controlled spontaneous electrolysis solution-prepared CuTCNQ microribbons as the source/drain electrodes, we have fabricated 9,10-bis(2-phenylethynyl)anthracene (BEPA) based organic single crystal top-contact field-effect transistors. The interfacial energetic match between organic semiconductors and CuTCNQ electrodes with the low contact resistance accounts for the co...

The surface tooth wear which occurs at the gear contact region due to inadequate contact strength of the tooth is one of the predominant modes of gear failures. Currently, higher contact ratio spur gears are increasingly used in power transmission applications such as aircraft, wind turbine, automobiles and compact tracked vehicles due to their high load carrying capacity.  In this work, the di...

An approximate analytical model is developed for predicting the thermal contact resistance of spherical rough solids with the presence of interstitial gases. The joint resistance includes four thermal resistances, that is, macrogap, microgap, macrocontact, and microcontacts. Simple relationships are derived for each component of the joint resistance assuming contacting surfaces are of uniform t...

The increase of shear strength in soil, reinforced with the geogrid (alternate reinforcer), is resulted from an increase of modulus of soil hardness, and also from the tensile strength of reinnforcer. The shear strength of contact surface in soil appears due to both the friction strength against the contact surface, and the passive strength formed in front of the elements of the geogri...

Current research in prosthetic device design aims to mimic natural movements using a feedback system that connects to the patient's own nerves to control the device. The first step in using neurons to control motion is to make and maintain contact between neurons and the feedback sensors. Therefore, the goal of this project was to determine if changes in electrode resistance could be detected w...

1 Contact author e-mail: [email protected] ABSTRACT A 3D electrothermal model is used to simulate and optimize Si/SiGe superlattice heterostructure micro-coolers. The model considers thermoelectric/thermionic cooling, heat conduction and Joule heating. It also includes non-ideal effects, such as contact resistance between metal and semiconductor, substrate/heatsink thermal resistance, the side c...

The source and drain electrode contact resistance of the hydrogenated amorphous silicon (a-Si:H) thin-film transistor (TFT) with a Schottky-barrier source/drain contact was measured using a gated-four-probe TFT structure. Typically its variation with the gate bias is considered to be independent of the gate bias but we observed that contact resistances decrease exponentially with increasing gat...

During the manufacturing process multi-strand conductors are subject to compressive force and rotation moments. The current distribution in the multi-strand conductors is not uniform and is controlled by the transverse resistivity. This is mainly determined by the contact resistance at the strand crossovers and inter-strand contact resistance. The surface layer properties, and in particular the...