In this present work, we propose and demonstrate a resonant structure that solves two major problems related to the split-ring resonator structure. One of the problems related to the split-ring resonator structure is the bianisotropy, and the other problem is the electric coupling to the magnetic resonance of the split-ring resonator structure. These two problems introduce difficulties in obtai...

A ring-resonator-based refractive index sensor is proposed in this paper. Glass filaments with surface guiding layers created by ion exchange are crossed with a fiber taper to act as a ring resonator sensor. Theoretical simulation of the sensor response is proposed, and optimization of structural parameters including thickness and refractive index of the surface guiding layer and the diameter o...

In this paper absorption loss & negative magnetic permeability feature of split ring resonator (SRR) is demonstrated & discussed at length for rectangular as well as circular geometry in microwave frequency region. Reflection as well as transmission parameter of SRR for the afro mentioned geometry is presented. The transmission shows a dip for propagation along the direction of split ring reson...

This paper shows the comparative analysis of a cylindrical dielectric resonator antenna (CDRA) fed by nonresonant microstrip patch and a proximity-fed planar annular slot (PPAS) antenna. The antenna array having an antenna element for higher directive gain at the center frequency 9.04 GHz. The band-notch is detained by almost a half-wavelength split-ring parasitic element printed around the rad...

This paper presents a new ultra-wideband (UWB) bandpass filter (BPF) with sharp roll-off and dual-notched bands. The filter consists of a triangle ring multi-mode resonator (MMR) with the stub-loaded resonator (SLR) for controlling the two transmission zeros at 2.8 / 11 GHz, the embedded open-circuited stub and the asymmetric tight coupled input/output (I/O) lines for introducing the dual notch...

The principle, fabrication and characterization of a dielectric MEMS cantilever located a few 100 nm above a racetrack ring resonator are presented. After fabrication of the resonators on silicon-on-insulator (SOI) wafers in a foundry process, the cantilevers were integrated by surface micromachining techniques. Off-state deflections of the cantilevers have been optimized to appropriately posit...

This paper addresses a modified bandpass ring resonator filter providing compact size, low insertion-loss, wide bandwidth, sharp rejection and suppressed higher order modes. The filter enhancement follows a threefold approach. First, UC-PBG structures are used to suppress the higher order passbands yielding an upper stopband that reaches 4.7 GHz, beside offering a further advantage in terms of ...

Recently, low threshold Raman silicon lasers based on ring resonator architecture have been demonstrated. One of the key elements of the laser cavity is the directional coupler that couples both pump and signal light in and out of the ring resonator from the bus waveguide. The coupling coefficients are crucial for achieving desired laser performance. In this paper, we report design, fabrication...

A ring resonator is patterned on a porous silicon slab waveguide to produce a compact, high quality factor biosensor with a large internal surface area available for enhanced recognition of biological and chemical molecules. The porous nature of the ring resonator allows molecules to directly interact with the guided mode. Quality factors near 10,000 were measured for porous silicon ring resona...