Hybrid Photovoltaic Thermal (PVT) collectors are an emerging technology that combines PV and solar thermal systems in a single solar collector producing heat and electricity simultaneously. The focus of this thesis work is to evaluate the performance of unglazed open loop PVT air system integrated on a garage roof in Borlänge. As it is thought to have a significant potential for preheating vent...

Solar energy is the highly recognized energy source, capable of fulfilling the world’s future energy demands. The solar photovoltaic technology involves the unmediated transformation of sunlight into electricity. A little fraction is converted into electricity and the remaining gets exhausted as unused heat. This results in an increase in the operating temperature of the PV Panel. The conversio...

in this paper, the electrical consumption of a research center building is derived of the bills, then with defining of fuzzy bus thermal coefficient objective function for heating, the amount of available heat selling to research center building consumer that is produced by biomass solar hybrid source is calculated. with the capacity determination of biomass solar hybrid source to provide therm...

The design process of a superconducting current limiter (SFCL) requires simulation and definition of its electrical, magnetic and thermal properties in form of equivalent circuits and mathematical models. However, any change in SFCL parameters: dimension, resistance, and operating temperature can affect the limiting mode, quench time, and restore time. In this paper, following the simulation of...

In the Railgun which is used to accelerate objects, electrical energy is used to drive the system. In order to reach hypervelocities, a power supply with immense amount of energy must be used which causes an extra ordinary current on the rail and the armature. This current makes thermal energy by the ohmic attenuation and warms up various points and therefore changes the electrical, thermal and...

The objective of this study was to achieve higher efficiency of a PV system while reducing of the cost of energy generation. Concentration photovoltaics was employed in the present case as it uses low cost reflectors to enhance the efficiency of the PV system and simultaneously reduces the cost of electricity generation. For this purpose a V-trough integrated with the PV system was employed for...

In this paper we present a dynamic model of a hybrid photovoltaic/thermal (PVT) collector with a sheetand-tube thermal absorber. The model is used in order to evaluate the annual generation of electrical energy along with the provision of domestic hot-water (DHW) from the thermal energy output, by using real climate-data at high temporal resolution. The model considers the effect of a non-unifo...

To properly estimate a thermoelectric material's performance, one should be able to characterize a single thermoelectric (TE) element with a large temperature gradient. In this work, we present an experimental setup including a Z-meter that can heat the sample to a very high temperature of 1200 °C in vacuum. The Z-meter can simultaneously measure all three thermoelectric parameters (Seebeck coe...