Small stationary diesel engines, like in generator sets, have limited emission control measures and are therefore responsible for 44% of the particulate matter (PM) emissions in the United States. The diesel exhaust composition depends on operating conditions of the combustion engine. Furthermore, the measurements are influenced by the used sampling method. This study examines the effect of eng...

This study presents an experimental investigation of a piston engine driven by compressed air. The compressed air engine was a modified 100 cm 3 internal combustion engine obtained from a motorcycle manufacturer. The experiments in this study used a test bench to examine the power performance and pressure/temperature variations of the compressed air engine at pressures ranging from 5 to 9 bar (...

In wake of the present energy environment crises it has become essential to identify renewable and alternative clean burning fuels. One of the significant routes to tackle the problem of increasing prices and the pollution problems of petroleum fuels is by the use of vegetable oil fuels known as biodiesels. In the present work biodiesel was prepared from Honge oil (Pongamia) and used as a fuel ...

An experimental study has been carried out to simultaneously optimize several diesel engine designs and operating parameters for low exhaust emissions using Taguchi method. A single cylinder (DPF make) diesel engine equipped with a high pressure, cam driven mechanical injector has been used in this experiment. The effects of changes in engine design/operating parameters–nozzle spray holes, pist...

Changing the compression ratio and presence of turbocharger are two important issues, affecting on performance, and exhaust emissions in internal combustion engines. To study the functional properties and exhaust emissions in regards to compression ratio at different speeds, the numerical solution of the governing equations on the fluid flow inside the combustion chamber and the numerical solut...

In this paper, the 2f/1f tunable diode laser wavelength modulation spectroscopy is used for the simultaneous measurement of concentration and temperature of CO2 in the exhaust plume of an aero engine. The suitability of the R48 spectral feature of CO2 at 1997.2 nm is discussed for this project and for further application of CO2 tomographic imaging on large-scale aero-engines. To ensure accurate...

in this study the performance and emissions characteristics of a heavy-duty, direct injection, compression ignition (ci) engine which is specialized in agriculture, have been investigated experimentally. for this aim, the influence of injection timing, load, engine speed on power, brake specific fuel consumption (bsfc), peak pressure (pp), nitrogen oxides (nox), carbon dioxide (co2), carbon mon...

Organic Rankine cycle (ORC) system is considered as a promising technology for energy recovery from the waste heat rejected by internal combustion (IC) engines. However, such waste heat is normally contained in both coolant and exhaust gases at quite different temperatures. A single ORC system is usually unable to efficiently recover energy from both of these waste heat sources. A dual loop ORC...

The launch of the new 1.8 l TFSI engine marks the third generation of the successful four-cylinder gasoline engine family from Audi. It has been completely revised in order to meet ambitious CO2 targets and ensure compliance with future Euro 6 emissions standards. The new generation features numerous innovative technologies, including an exhaust gas cooling system integrated into the cylinder h...