Routing in Wireless Sensor Networks (WSNs) is a very challenging task due to the large number of nodes, their mobility and lack of proper infrastructure. Since the sensors are battery powered devices, energy efficiency is considered as one of the main factors in designing routing protocols in WSNs. Most of energy-aware routing protocols are mere energy savers that attempt to decrease the energy...

using greedy clustering method to solve capacitated location-routing problem with fuzzy demands abstract in this paper, the capacitated location routing problem with fuzzy demands (clrp_fd) is considered. in clrp_fd, facility location problem (flp) and vehicle routing problem (vrp) are observed simultaneously. indeed the vehicles and the depots have a predefined capacity to serve the customerst...

Today, one of the new technologies in the modern era is Vehicular Ad-hoc Network which has takenenormous attention in the recent years. Because of rapid topology changing and frequent disconnectionmakes it difficult to design an efficient routing protocol for routing data between vehicles, called V2V orvehicle to vehicle communication and vehicle to roadside infrastructure, called V2I. Designin...

a microgravity survey was conducted for detecting the sink-holes at site of a power plant. pits, man-made tunnels and canals were considered as topographical effects and were corrected. to show the capability of the method two sites in a power plant have been surveyed for existing areas which can be affected by sink-holes overnight. ground shakes due to the running facilities were also preventi...

Reinforcement learning (RL) has been successfully applied to underwater routing protocols due its powerful ability of distributed decision making. However, the traditional RL slow convergence speed and low efficiency in underwater. Meanwhile, too many studies focus on using find hop paths rather than short distance routing, while long ocean communication is significant reason for packets collis...

Routing in Wireless Sensor Networks (WSNs) is a very challenging task due to the large number of nodes, their mobility and lack of proper infrastructure. Since the sensors are battery powered devices, energy efficiency is considered as one of the main factors in designing routing protocols in WSNs. Most of energy-aware routing protocols are mere energy savers that attempt to decrease the energy...

By increasing, the complexity of chips and the need to integrating more components into a chip has made network –on- chip known as an important infrastructure for network communications on the system, and is a good alternative to traditional ways and using the bus. By increasing the density of chips, the possibility of failure in the chip network increases and providing correction and fault tol...

in recent years, routing has been the most focused area in ad hoc networks research. on-demand routing in particular, is widely developed in bandwidth constrained mobile wireless ad hoc networks because of its effectiveness and efficiency. most proposed on-demand routing protocols are built and relied on single route for each data session. whenever there is a link disconnection on the active ro...