Instrumented Charpy test data can be used to obtain estimates of dynamic yield strength, by means of a well-established relationship published by W. Server in 1978. A fundamental issue in comparing measured dynamic tensile properties and Charpy-based estimations is establishing the equivalent uniaxial strain rate for an instrumented Charpy test, typically conducted at ≈ 5.5 m/s. In this investi...

A two-dimensional finite element model of a mandibular quadrant was used to examine differences in magnitude of the principal stresses from the placement of three- and four-unit bridges. The area of interest spanned the first premolar to the second molar. Loading conditions were (i) vertical and distributed and (ii) 30 degrees to the vertical and concentrated. The principal stresses were calcul...

Laser welding has a large potential for the production of tailor welded blanks in the automotive industry, due to the low heat input and deep penetration. However, due to the small laser spot and melt pool, laser-based welding processes in general have a low tolerance for seam gaps. In this paper, five laserbased welding techniques are compared for their gap bridging capabilities: single-spot l...

the creep behavior of basalt fiber reinforced epoxy (bfre) and glass fiber reinforced epoxy (gfre) composites was studied through tensile testing at high temperature. to study the effect of reinforcing epoxy, the micro glass powder (mgp) was added at various volume percentage into the epoxy resin in bfre composites. the initial strain for all the specimens were evaluated and compared with each ...

In the present study, two types of tests (tensile strength test and polymerization inhibition test) were performed to evaluate the physical and chemical properties of four impression materials [a polysulfide (Permlastic), a polyether (Impregum), a condensation silicone (Xantopren) and a polyvinylsiloxane (Aquasil)] when polymerized in contact with of one conventional (Hemostop) and two experime...

This paper presents the results of an experimental study on the effect of limestone powder on the compressive strength, tensile behavior, and micromechanical parameters of a highly ductile cement composite incorporating limestone powder. Four mixtures were determined according to the replacement ratio of cement with limestone powder. A series of experiments including compressive strength, uniax...

The paper describes tests carried out on disc valves of varying thickness and operating on seats of different profile when subjected to sudden changes of pressure across the valve. These changes of pressure were produced in a shock tube SO mm in diameter. The high pressure chamber was 0. 6 m long, while the low pressure chamber was 2.125 m long. A drum camera, synchronised to the pressure pulse...

Deformation behaviour of rolled AZ31 sheets that were subjected to the accumulative roll bonding was investigated. Substantially refined microstructure of samples was achieved after the first and second pass through the rolling mill. Sheets texture was investigated using an X-ray diffractometer. Samples for tensile tests were cut either parallel or perpendicular to the rolling direction. Tensil...