Exergy analysis is based on combined first and second laws of thermodynamics and is a useful tool to analyze the energy systems in a better and more realistic way than an energy analysis, based on the first law of thermodynamics. Combination of exergy from thermodynamics with conventional concepts from engineering economy which is referred to as thermo-economy (exergo-economy) is a valuable too...

Climate change occasioned by the accumulation of greenhouse gases (GHGs) is now widely accepted as an issue which mankind needs to address. The starting point is necessarily the determination of all the sources of emissions during the life-cycles of the studied components. Post-calculation, the results ought to be presented to decision-makers in a clear manner so as to provide the basis on whic...

Hysteresis current control method is vastly used in PWM inverters because of simplicity in performance, fast control response and good ability in limiting peak current. However, switching frequency in hysteresis current control method with fixed bandwidth has large variation during a cycle and therefore causes non-optimal current ripple generation in output current. One of basic problems in imp...

In a walking cycle design, maximizing the upright balance should be considered in addition to the kinematic constraints, energy consumption rate must be considered. The purpose of this study is to find the optimal step length obtained for each person according to the physical features. In this research, in order to minimize energy consumption rate by considering maximum balance two cost functio...

As processor demands quickly outpace memory, the performance of load instructions becomes an increasingly critical component to good system performance. This thesis contributes four novel load latency reduction techniques, each targeting a di erent component of load latency: address calculation, data cache access, address translation, and data cache misses. The contributed techniques are as fol...

in the present work, multidimensional modeling of open-cycle process of om355 engine was developed. calculations for computational mesh were carried out. the results of the model were validated by experimentally measured in-cylinder pressure and the good agreement between calculations and measurements approved the trustworthy of numerical code. results included pressure, temperature, emission a...