2014 The present paper reviews the problem of short term thermal energy storage for low temperature solar heating applications. The techniques of sensible and latent heat storage are discussed, with particular emphasis on the latter. Requirements for hot water storage subsystems are provided and the importance of stratification in hot water storage tanks is described. Concerning latent heat sto...

We developed an equation of state (EOS) by Ihm, Song, and Mason (ISM) for polar fluids. The model consists of four parameters, namely, the second virial coefficient, an effective van der Waals co-volume, a scaling factor, and the reduced dipole moment. The second virial coefficient is calculated from a correlation that uses the heat of vaporization, and the liquid density at the normal boiling ...

Article history: Received 28 April 2008 Received in revised form 2 October 2008 Accepted 3 December 2008 Latent heatflux in the South China Sea (SCS)mainly based on the Tropical RainMeasuringMission Microwave Imager (TMI) is comparedwith the Objectively Analyzed air-sea heat Fluxes (OAFlux), theGoddard Satellite-BasedSurface Turbulent Fluxes, version2 (GSSTF2), the JapaneseOcean Flux Data Sets ...

Cooling technology becomes more important because of the increase in heat generation density of semiconductor chips. Boiling and two-phase flow is expected as one of the most effective methods to cool the electronic devices because of its superior heat transfer characteristics. Because the boiling heat transfer depends on the selection of coolant, the development of liquid mixtures and their co...

Actual evapotranspiration is assessed via surface energy balance at an hourly rate. However, a robust estimation of daily evapotranspiration from hourly values is required. Outcomes of surface energy balance are frequently determined via measures of eddy covariance latent heat flux. Surface energy balance can be applied on images acquired at different times and spatial resolutions. In addition,...

The energy requirement of vacuum membrane distillation (VMD) with or without recirculation was modelled using both experimental results and theoretical data. The trends are generally consistent between the theoretical and experimental data. Thermal energy contributes the most to the total energy required for the VMD process. To lower the thermal energy cost, waste heat resource and heat recover...

Water-cooled chiller systems have typically been designed around entering condenser water temperatures of 85°F with a Optimization of Water Cooled Chiller – Cooling Tower Combinations The warm water leaving the chilled water coils is pumped to the evaporator of the chiller, where the unwanted heat from the building is transferred by the latent heat of vaporization of the refrigerant. The compre...

The literature pertinent to various aspects of drop evaporation on a heated surface is reviewed. Both the laser shadowgraphic and direct photographic methods are employed to study thermal stability and flow structures in evaporating drops in all heating regimes. It is revealed that four flow regions exist in stable and unstable type drops at low liquid-film type vaporization regime. As the surf...

Droplet vaporization models that are currently employed in simulating sprays are based on a quasisteady, low-pressure formulation. These models do not adequately represent many high-pressure effects, such as nonideal gas behavior, solubility of gases into liquid, pressure dependence of gasand liquid-phase thermophysical properties, and transient liquid transport in the droplet interior. In the ...