electrostatic potential as well as the local volume charge density are computed for a macromolecule by solving the poisson-boltzmann equation (pbe) using the finite element method (fem). as a verification, our numerical results for a one dimensional pbe, which corresponds to an infinite-length macromolecule, are compared with the existing analytical solution and good agreement is found. as a ma...

stability of foundations near slopes is one of the important and complicated problems in geotechnical engineering, which has been investigated by various methods such as limit equilibrium, limit analysis, slip-line, finite element and discrete element. the complexity of this problem is resulted from the combination of two probable failures: foundation failure and overall slope failure. the curr...

superplastic materials show a very high ductility. this is due to both peculiar process conditions and material intrinsic characteristics. however, a number of superplastic materials are subjected to cavitation during superplastic deformation. evidently, extensive cavitation imposes significant limitations on their commercial application. the deformation and failure of superplastic sheet metals...

this paper presents an overview of model updating and particularly its application for updating of frame model. in this article a mathematical model of the frame was produced with finite element method. the frame was subjected to hammer modal testing. then the results of the modal testing were compared with those predicted with the model. this comparison revealed discrepancies between these two...

We describe a hybrid method which combines the boundary element method (BEM) and the finite element method (FEM) to compute circuit models for layout dependent capacitances. The method can handle irregularities in the stratification of the layout of the integrated circuits (IC’s). New in the method are the models for the interface between the regions where the BEM and the FEM are applied. We sh...

this paper presents a method for diagnosis of eccentricity fault in a switched-reluctance motor (srm) during offline and standstill modes. in this method, the fault signature is differential induced voltage (div) achieved by injecting diagnostic pulses to the motor windings. it will be demonstrated by means of results that there is a correlation between differential induced voltage and eccentri...

one of the bellows producing method is hydroforming process .whereas some factor of hydroforming process specially internal pressure affects on final characteristics produced bellows such as bursting, wrinkling and wall thickness distribution. in this paper the effect of internal pressure factor in final quality of produced bellows will be investigated. in simulation of process, abaqus/explicit...

nowadays, one of the main problems encountered in minimally invasive surgery and telesurgery is the detection of arteries in tissue. in this study, for the first time, tactile detection of an artery in tissue and distinguishing it from the tumor has been modeled by finite element method. in this modeling, three 2d models of tissue have been created: tissue, tissue including a tumor, and tissue ...

a new approach is proposed to model a crack in orthotropic composite media using the extended finite element method (xfem). the xfem uses the concept of partition of unity in addition to meshless basic idea of approximating a field variable by its values at a set of surrounding nodes. as a result, higher order approximations can be designed with the same total number of degrees of freedom. in t...