heat transfer phenomena in batch fluidized bed dryer have been studied and analyzed using three phase model including solid phase, interstitial gas phase and bubble phase based on rizzi model. new correlations of heat transfer coefficient to surrounding and convection heat transfer coefficient between solid and interstitial gas are being proposed. in addition, some modifications have been done ...

nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. in this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in pure ...

Analysis of intrinsic irreversibility and heat transfer in a buoyancy-driven changeable viscosity liquid along an incline heated wall with convective cooling taking into consideration the heated isothermal and isoflux wall is investigated. By Newton’s law of cooling, we assumed the free surface exchange heat with environment and fluid viscosity is exponentially dependent on temperature. Appropr...

Two-phase heat transfer is experimentally examined through vertical small diameter tubes, D =1.45 and 2.8 mm using water under a pressure of 50 to 81 kPa and a natural circulation condition. The pool boiling correlation by Stephan-Abdelsalam and the thermosyphon boiling correlation by Imura, et al. predict the measured experimental data in the 2.8 mm tube with an error of -30%. A large heat tra...

natural convective heat transfer of nano-fluid in porous media is present in many advanced engineering applications. in this work, this problem has been computationally simulated, using lbm. the configuration used includes a cold exterior region and hot interior cylinders with one-, two-, or three-cylinder arrangements. however, the effective area for heat transfer has been kept the same for al...

The nonlinear dynamics of and heat and mass transfer processes in annular liquid jets are analyzed by means of a nonlinear system of integrodi€erential equations which account for the liquid motion and the gases enclosed by the jet. Both linear and sinusoidal heat and mass addition sources are considered to take place homogeneously within the volume enclosed by the jet's inner interface in an a...

Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...

Natural convection heat transfer was investigated experimentally in a concentric-cylinders annulus. To enhance the rate of heat transfer, pin fins were installed on the surface of the inner cylinder. Two fin arrangements were employed, namely, staggered and in-line arrangements. The length of the fins varied from 2 to 8 cm and the Rayleigh number Ra changed in the range from 5 x 105  to 5 x 106...

The liquid motion induced by surface tension variation, termed the thermocapillary or Marangoni effect, and its contribution to boiling heat transfer has long been a very controversial issue. In the past this convection was not the subject of much attention because, under terrestrial conditions, it is superimposed by the strong buoyancy convection, which makes it difficult to obtain quantitativ...