his study used quantitative image analysis to examine the effect of powder forming method on a population of dense heterogeneities that could e imaged in partially sintered alumina using optical microscopy. Powder pressing resulted in a higher area fraction of dense heterogeneities than lip casting. Extreme value analysis was used to predict the size of the largest heterogeneity in the populati...

The aim of this study was to establish a relationship between the mechanical properties of a powder coating, extracted using ultrasonic analyses, and the extent of its curing. This study was necessitated by the fact that most current methods either focus on in-process temperature monitoring or on laboratory analysis of powder samples and not on post-curing characterization of industrial samples...

Polyetheretherketone (PEEK) was reinforced with 0-40 vol% hydroxyapatite (HA) whiskers using a novel powder processing and compression molding technique. A powder mixture was uniaxially pressed into a composite powder compact and compression molded into a flat composite bar using an open-channel die, such that the HA whiskers exhibited a preferred orientation along the length of the bar and ten...

In Powder Metallurgy the knowledge of the mechanisms governing the deformation behaviour of the material during its processing is in an initial stage due to the lack of an elasto-plastic model that could explain the mechanical behaviour, specially when the initial stage of powder die compaction is the one to be considered. For this reason geological models such as Cam-clay and Cap [1, 2, 3, 4] ...

In this work, sol-gel processing was used to synthesize the fluorohydroxyapatite (nano-FHA, Ca10(PO4)6(OH)2−xFx) nanopowders. The advantages of the sol-gel method over other methods are precise control of composition, low processing temperature, and better homogeneity. Calcium nitrate tetrahydrate, phosphorous pentoxide and Tetrabuthylammon...

The objective of this study was to establish the mechanism(s) controlling degradation of yttria-tetragonally-stabilized zirconia (Y-TZP) powder in aqueous suspensions and determine the significance of this degradation to the aqueous physical chemistry of Y-TZP. Experiments were performed on commercially available Y-TZP powder placed in aqueous suspensions at 25°C. Experimental investigations in...

The current investigation shows the feasibility of 316L steel powder production via three different argon gas atomisation routes (closed coupled atomisation, free fall with and without hot gas), along subsequent sample by laser bed fusion (PBF-LB). Here, a mixture pure Fe atomised is used for PBF-LB to induce chemical composition gradient in microstructure. Optical microscopy μ-CT investigation...

The development of novels materials represents a new and fast evolving application of research in physics and medicine. Processing synthesis is critical because it generally controls the final properties of the materials, ceramic forming techniques are generally based on powder processing with powder synthesis, forming and sintering. Moreover, ceramic processing has also to consider other techn...

In this study, the effect of some processing parameters on bulk density, particle density, particle size and some of powder reconstruction properties such as dispersibility, Wettability and water solubility index of spray dried barberry (Berberis vulgaris) juice powders were investigated. A Pilot Spray Dryer (Two- Flow nozzle, counter- current, one cyclone) was employed for the spray d...