The purpose of this study was to evaluate ascorbic acid (AS) and ferric chloride (FE) for bonding 4-META/MMA-TBB resin to dentin that had been treated with NaClO. An experimental dentin conditioner consisting of 10%AS and 5%Fe (10AS-5FE) and three controls (10AS-0FE, 0AS-5FE, and 0AS-0FE) were prepared. Ascorcic acid neutralizes NaClO. The flattened dentin surfaces were modified sequentially wi...

objective: comparing the effect of repeated opening of the container lid of two dentin adhesive systems, prime&bond; nt (p&b; nt) and ibond (ib), on shear bond strength. materials and methods: intact bovine lower incisors (n=60), fixed in acrylic were ran-domly divided into six groups (n=10). groups i and ii were set as control groups. p&b; nt and ib were applied on the samples after five days ...

PURPOSE Cementation failures of restorations are frequently observed in clinical practice. The purpose of this study is to compare the effect of initial and repeated bonding on the bond strengths of different resin cements to enamel and dentin. MATERIALS AND METHODS Ninety human maxillary central incisors were bisected longitudinally. The 180 tooth halves were divided into 2 groups (n = 90) f...

OBJECTIVES This study evaluated the effect of errors commonly made in using total-etch adhesives, on the resulting bond strength, fluid movement and nanoleakage of resin dentin bonds. METHODS Two total-etch adhesives were used for bonding to dentin according to the manufacturers' recommendations, with meticulous solvent evaporation (control), or with the introduction of common bonding errors-...

This study evaluated the extent of water penetration through resin-dentin interfaces before and after being sealed with adhesives. Four adhesive resin systems (2 total-etch adhesives and 2 self-etching primer adhesives) were used in this study. Dentin disks were placed in a split-chamber device, and in situ fluid movement across dentin was measured, with and without physiological pressure, duri...

Moisture contamination of etched enamel during application of sealant is the most frequently cited reason for sealant failure. In preliminary studies, a dentin bonding agent (Scotchbond Dual Cure, 3M, St. Paul, MN) has been shown to bond adequately to etched enamel after salivary contamination. This study investigated bond strength in vitro, when a bonding agent was used beneath sealants under ...

STATEMENT OF PROBLEM Delayed dentin sealing is traditionally performed with indirect restorations. With this technique, dentin is sealed after the provisional phase at the cementation appointment. It was demonstrated that this chronology does not provide optimal conditions for bonding procedures. Immediate dentin sealing (IDS) is a new approach in which dentin is sealed immediately following to...

objective: adverse surface interactions between one-bottle adhesives and chemical-cured composites may occur with delayed light activation of light-cured composites. the purpose of this study was to assess the effects of delayed activation of light-cured composites on shear bond strength of two one-bottle adhesives with different acidity to bovine dentin. materials and methods: flat dentin surf...

This clinical report describes a repair protocol for cusp fracture of a failed amalgam-dentin complex. A maxillary right first premolar with an amalgam restoration presented a buccal cusp fracture. Chairside repair has been undertaken by conditioning the existing amalgam restoration with silica coating (30 μm CoJet®-Sand), phosphoric acid etching the beveled enamel surface, priming dentin, and ...