The justification of implementing PAPR reduction schemes in OFDM is discussed. Decreasing PAPR increases the efficiency of the linear power amplifier, yielding an increase in average power emitted and consequentially an increase in capacity. However, implementing a PAPR reduction scheme s such as Tone Reservation or Selective Mapping means a decrease in the payload bandwidth which causes a decr...

The destructive impact of fading environments and also bandwidth limitations are two main challenges which communication is dealing with them. These challenges can affect on the growth of wireless communication and even cause reliable communications and high data rate to be prevented. Thus, OFDM (Orthogonal Frequency Division Multiplexing) modulation by using of fast calculation hardwares such ...

A Charge Recycling Sense Amplifier Based Logic is presented. This logic is derived from the Sense Amplifier Based Logic, which is a logic style with signal independent power consumption. It has been proven previously to protect security devices such as Smart Cards against power attacks. Experimental results show that the use of advanced circuit techniques, which enable charge recycling and inte...

In this work, the construction of a single stage L-band erbium-doped fiber amplifier which incorporates a short 5.1 m erbium doped fiber coil is described. Gain and noise figure measurements as a function of forward, backward and counter-propagating CW 1480 nm pumping schemes at different pump power levels are presented. Further, the Erbium Doped Fiber Amplifier (EDFA) power conversion efficien...

This paper presents an UWB low noise amplifier (LNA) based on current reused topology to achieve low power on overall circuit in the band of 3~16GHz. Measurement of the input and output reflection coefficient S11, S22 are less than 10 dB, the maximum amplifier gain S21 gives 9.7dB, the minimum of the noise figure is 4.2dB, the measured IIP3 is 8.5dBm at 6GHz. It consumes 11mW power consumption ...

In today's world of ever-increasing low-power portable electronics, from implants to wireless accessories, powering these devices efficiently and conveniently is an escalating issue. The proposed solution is to wirelessly recharge these lower-power portable devices through a common magnetic link with a higher-power portable device, such as a smartphone. Such a method is convenient for users, en...

but is no longer kept current and may contain obsolete or inaccurate references. We regret any inconvenience this may cause. For the latest information on Agilent's line of EEsof electronic design automation (EDA) products and services, please go to: Active linearization has become an important technology in modern communications systems. The emphasizes on higher data rates and spectral efficie...

Extremely fast animal actions are accomplished with mechanisms that reduce the duration of movement. This process is known as power amplification. Although many studies have examined the morphology and performance of power-amplified systems, little is known about their development and evolution. Here, we examine scaling and modularity in the powerful predatory appendages of a mantis shrimp, Gon...

A new symmetrical topology switching power amplifier is introduced for professional audio use. The amplifier is composed by a pair of semi soft switched half-bridges with independent feedback control. Whole overall layout looks very similar than an already bridge configured stereo amplifier with few exceptions. Although the complexity of the proposed topology is at least twice of the convention...

Conventional outphasing power amplifier systems require both an RF carrier input and a separate baseband input to synthesize a modulated RF output. This work presents an RF-input / RF-output outphasing power amplifier that directly amplifies a modulated RF input, eliminating the need for multiple costly IQ modulators and baseband signal component separation as in previous outphasing systems. An...