INTRODUCTION: Mechanical analogue composite bone models have been used as cadaveric bone substitutes in a wide variety of biomechanical tests. The objective of this study was to validate the diaphyseal structural properties in terms of flexural rigidity, ultimate bending strength, axial stiffness, ultimate compression strength, ultimate torsional strength, torque angle at ultimate torsional str...

Bending manipulation and direct force measurements of ultrathin boron nitride nanotubes (BNNTs) were performed inside a transmission electron microscope. Our results demonstrate an obvious transition in mechanics of BNNTs when the external diameters of nanotubes are in the range of 10 nm or less. During in situ transmission electron microscopy bending tests, characteristic "hollow" ripple-like ...

We investigate the mechanical properties of copper (Cu) octet-truss nanolattices through a combination of classical molecular dynamics (MD) simulations and theoretical analysis. The MD simulations show that Cu nanolattices with high relative density are stronger than bulk Cu, while also achieving higher strength at a lower relative density as compared to Cu meso-lattices. We demonstrate that mo...

The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...

This paper presents a methodology for the assessment of ductility and strength capacities in low-rise buildings. This method utilizes the characteristics of force-displacement for the lowest story level or considers the weakest story in any given low-rise building for its primary analysis. Calculations are based on two levels of earthquake motions, namely strong earthquakes (PGA=0.3 g), and ver...

In this study, 90 boards of Norway spruce (Picea abies (L.) Karst.) sized 48 x 148 mm in cross-section, have been examined using different scanning and measurement techniques. All of the boards originated from a sawmill located in southern Finland. Planar X-ray scanning, microwave scanning, and grain-angle measurement have been performed. In addition, strength and elastic properties were assess...

We have used a circular permutation gel shift assay to show that the 5S gene transcription factor, TFIIIA, induces a bend at the internal promoter of the Xenopus oocyte-type 5S gene. The degree of bending is comparable to what we have previously observed for TFIIIA induced bending of the Xenopus somatic-type gene [Schroth, G.P. et al. (1989) Nature 340, 487-488]. In addition, we show that TFIII...

This study compared the biomechanical performance of 4.5-mm limited-contact dynamic compression plates and 3.5-mm locking compression plates for the fixation of unstable humeral shaft fractures. Composite humeri were divided into two groups: 3.5mm LC and 4.5-mm LCDC plates. Osteotomy gaps of 5-mm, simulating diaphyseal comminution, were created. Stiffness tests were performed in anterior-poster...

(RCS) frames which are systems that dwell of concrete columns and steel beams , by optimizing the act of compressive strength of concrete and bending strength of steel due to not only a decrease in building weight in comparison to concrete structures but also having a better action in long spans frames . In this paper for analysis RCS behavior, a category of nonlinear Push Over analyses were ...

The human bone is multiphase material consisting of collagenous matrix interspread with mineral crystals. Magnesium participates in the normal formation and remodelling of bone. Magnesium deficiency has been associated with a number of clinical disorders including osteoporosis. The present investigation focuses on quantitative estimation of magnesium, an inorganic constituent of bone and determ...