generally, fatigue failure in an element happens at the notch on a surface where the stress level rises because of the stress concentration effect. the present paper investigates the effect of a notch on the fatigue life of the hsla100 (­high strength low alloy) steel which is widely applicable in the marine industry. tensile test was conducted on specimens and mechanical properties were obtain...

master moulds are used to cast copper anode moulds. these iron moulds are made of grey or nodular cast irons. according to desirable properties of ductile irons, it was expected that ductile cast iron moulds could have performed their nominal life. but in service, these moulds have not performed their nominal life and they have experienced premature failures due to warping and cracking. also gr...

There is an increasing demand for air-dry performance of fluorocarbon finished materials. Thus, dyeing with different types of reactive, mono, bi, and multi-functional, dyes was evaluated as a novel treatment to create correct surface interface to maintain fluorocarbon performance without ironing or tumble drying. The effects of pre-treatment on fluorocarbon finishing of cotton fabric, a cellul...

This study investigated the residual tensile properties of plain woven jute fiber reinforced poly(lactic acid) (PLA) during thermal cycling. Temperature ranges of thermal cycling tests were 35-45 °C and 35-55 °C. The maximum number of cycles was 10³ cycles. The quasi-static tensile tests of jute fiber, PLA, and composite were conducted after thermal cycling tests. Thermal mechanical analyses of...

This investigation is concerned to evaluate the influence of heat treatment on mechanical behavior of AISI1040 steel; it is one of the grades of medium carbon steel of American standard containing 0.40% carbon in its composition. Specimen of quenched/hardened AISI1040 steel was tempered at temperature (650,450&250°C) for 60, 90&120 minutes to modify desired properties. The mechanical behavior, ...

Polyols were synthesized from epoxidized natural oils and tetrahydrofuran through ring opening copolymerization catalyzed by Lewis acid. The properties of these polyols depend on the type of natural oils as well as the reaction conditions (monomer concentration, catalyst amount, reaction temperature and reaction time). These polyols were evaluated as a raw material for making polyurethane (PU) ...

The effect of Au addition on the microstructural and the tensile properties of Sn–0.7 mass%Cu alloy was examined. Tensile strength and 0.2% proof stress remarkably increase up to 0.3 mass%Au primarily due to solid solution hardening. Beyond 0.3 mass%Au, due to precipitation of large intermetallic compounds, elongation decreases while tensile strength and 0.2% proof stress increase slightly. Wit...