The proper ratio decision of sintering burden is a significant section for both of decreasing sintering costs and increasing quality of iron. At present most company in China take the Fixed-ratio method and linear programming (LP) model to calculate the proper ratio for sintering. The former is the performance appraisal method for production cost management of iron. The latter is to use maths m...

This paper presents a novel derivative of flash sintering, in which contactless flash sintering (CFS) is achieved using plasma electrodes. In this setup, electrical contact with the sample to be sintered is made by two arc plasma electrodes, one on either side, allowing current to pass through the sample. This opens up the possibility of continuous throughput flash sintering. Preheating, a usua...

A commercially available Y-TZP ceramic powder was fabricated under four different sintering profiles in order to investigate the effects of conventional single-stage sintering (SSS) with dwell times of 1 min and 2 h, respectively, compared with two-stage sintering (TSS), on the physical and mechanical properties of Y-TZP. Sintering was performed up to 1400 o C at a ramp rate of 10 o C/min. It w...

We report herein the development and preliminary mechanical characterization of fully-dense multi-wall carbon nanotube (MWCNT)-reinforced ceramics and glasses based on a completely new methodology termed High Shear Compaction (HSC). The tubes are introduced and bound to the matrix grains by aid of polymeric binders to form flexible green bodies which are sintered and densified by spark plasma s...

The porosity and architecture of bone scaffolds, intended for use in bone repair or replacement, are two of the most important parameters in the field of bone tissue engineering. The two parameters not only affect the mechanical properties of the scaffolds but also aid in determining the amount of bone regeneration after implantation. Scaffolds with five different architectures and four porosit...

the effects of electronic properties of inner and outer surfaces of carbon nano tubes (cnts) on the deactivation of cobalt fischer-tropsch (ft) catalysts were studied. the comparative characterization of the fresh and used catalysts by tem, xrd, tpr, bet and h2 chemisorption showed that cobalt re-oxidation, cobalt-support interactions and sintering are the main sources of catalyst deactivation....

In this study, mechanically alloyed Al 2024 powder is densified by conventional sintering and by equal channel angular pressing (ECAP) with and without back pressure. The powder was encapsulated in an aluminium can for consolidation through ECAP. The properties obtained in the compacts by conventional sintering route and by ECAP are compared. The effect of conventional sintering and ECAP on con...

II-VI semiconductors form an important class of opto-electronic materials. CdSe is a promising material for the fabrication of photovoltaic devices. Polycrystalline CdSe films have been deposited onto ultra clean glass substrates by sintering process. The optical band gap of these films was determined by reflectance measurements in wavelength range 400-850 nm. The band gap of these films was ob...

The residual porosity is an unavoidable phenomenon of the components produced by powder metallurgy process which in turn largely affects the strength property of the same. Now a day it is possible to control porosity of powder metallurgy components and retain them to desired amount when required. The porosity of a powder metallurgy component is greatly depends on the sintering temperature. In t...