Surface microsurgery is the science of preparing surface layers, such as oxide scales and coatings, for characterisation of their microstructure and composition, by conventional surface analytical techniques, such as SEM, EPMA, SIMS etc. A surface microsurgery procedure often employed involves the preparation of a taper section. Using relatively simple equipment, significant improvements have b...

An axially corrugated horn antenna with an elliptically shaped taper is proposed for satellite communication applications. This structure is a good candidate for the feed of reflectors and also for improving the electrical properties of reflector antennas. A tapering method is used to justify the horizontal location of the corrugation profile which improves the electrical performance of the pre...

In friction stir welding frictional heat is generated by the rotating tool, sliding over the stationary plate along the weld centre. Tool being the only source of heat producing member, its geometrical design influences the heat generation rate. In this present work, effects of variation in tool shoulder and tool pin taper angles on thermal history during joining are analysed. Tools with triang...

OBJECTIVE Widespread use of rotary nickel-titanium systems has caused manufacturers to produce gutta-percha cones that match the taper of the canals prepared with these systems. Obturations with these cones may provide 3-dimensional obturation of the root canal in less time. The aim of this study was to use a fluid filtration method to compare the apical sealing ability of matched-taper single-...

A compact, highly sensitive optical fiber displacement and curvature radius sensor is presented. The device consists of an adiabatic bi-conical fused fiber taper spliced to a single-mode fiber (SMF) segment with a flat face end. The bi-conical taper structure acts as a modal coupling device between core and cladding modes for the SMF segment. When the bi-conical taper is bent by an axial displa...

This study used transparent epoxy-resin root canal models to evaluate different main root canal tapers and various methods of vertical compaction for warm gutta-percha obturation of lateral depressions. The root canal models had straight main root canals with three tapers and four lateral depressions at right angles to the main root canal, 1.0 mm and 3.0 mm from the apex. Three types of experim...

The goal of this study was to compare the apical cleaning capabilities of single files from 3 different rotary systems in the presence or absence of prior cervical preparation based on a histological analysis. A total of 84 human single-rooted mandibular permanent incisors were divided into 6 groups (14 canals each). Cleaning and shaping was performed under the following protocols: Group I, F2 ...

The aim of this study was to quantitatively evaluate the amount of apically extruded debris by single-file reciprocating instruments with different working lengths and apical preparation sizes. Eighty human single-rooted mandibular incisors were used and conventional access cavities were prepared. Then, the specimens were divided into four groups (n=20), according to root canal instrumentation:...