Solar water heaters are good tools for saving fuel. The main component of these water heaters is collectors, which are responsible for absorbing solar energy and transferring it to the working fluid with the least heat dissipation. The present study is an experimental study of the performance of the solar semispherical collector with 1 m2 of absorber area at different volumetric flow...

In the present work the efficiency of a solar parabolic trough has been investigated experimentality. parabolic trough solar collector constitute a proven source of thermal energy for industrial process heat and power genaration. The impact of  using the partially porous media in the absorber on the efficiency of PTC (parabolic trough collector) has been investigated. The porosity of copper foa...

In this paper, artificial neural networks (ANNs) and genetic algorithms (GAs) are used for the design of solar flat-plate collectors. It is proved in this paper that by using the Taguchi method for selecting the data required for training the ANN is very effective in allowing the network to learn the behavior of the system satisfactorily. The parameters on which the flat-plate collector design ...

A solar absorption icemaker was designed. It is an intermittent system and uses Calcium Chloride and Ammonia as absorbent and refrigerant respectively. The single glazed collector/absorber/generator unit uses a plane glass sheet as the outer cover. Overall collector plate exposed area is 1.0m. A thermodynamic simulation of the icemaker has been performed in order to investigate the effect that ...

A system is being tested for recovery of rf power by conversion to DC pulsed power. The system consists of a cyclotron autoresonance accelerator (CARA) [1,2], and a single stage depressed collector (Fig. 1). A 50 kV, 5 A electron beam is injected into CARA, and up to 1 MW of S-band rf power is absorbed by the beam with efficiency exceeding 95%. The beam then passes to a single stage depressed c...

The shape of a solar collector is an important factor in solar-to-thermal energy conversion. Conical shape is one of the stationary and symmetric shapes that can be employed as a solar water heater. Flow rate of working fluid on the solar collector has an important effect on the efficiency of the collector. The present study is an experimentally investigated of the performance of the solar coni...

in this research a flat plate solar air collector was investigated under direct solar radiation consisted of a slatted glass cover, perforated absorber aluminum sheets (porosity 0.0177, 0.0314 and absorber thickness of 2.5 mm). the effect of porosity on absorber efficiency of collector was evaluated. six levels of air mass flow rates (0.0056 to 0.0385 kg m-2 s-1) were adopted.average solar ener...

Multistage collectors are commonly used in travelling wave tubes (TWTs), klystrons, gyrotrons and inductive output tubes (IOTs). A dc beam transfers some of its energy to the input RF wave during its travel through the interaction circuit. The purpose of a collector is to recover most of the remaining dc power from the spent beam and thereby increase both the collector and the overall efficienc...

outdoor experiments on a once-through single glazed solar air heater with perforated metal absorber plate were conducted to determine the practical effect of absorber plate porosity as well as suction air flow rate on the collector thermal efficiency and its total pressure drop. three aluminum absorber plates were made perforated by drilling circular holes with different diameter/pitch ratios i...

The possibility of using flat plate collector in northern parts of Iran specially city of Rasht has been investigated in this paper. According to the high humidity in the northern parts of this country, diffuse radiation plays a more important role than direct radiation. This fact can change the results of delivered solar energy and the best tilt angle of the collector compared to the sunny cen...