Steel corrosion of bars in concrete structures is a complex process which leads to the reduction of the cross-section bars and decreasing the resistance of the concrete and steel materials. In this study, reliability analysis of a reinforced concrete beam with corrosion defects under the distributed load was investigated using the enhanced Hasofer-Lind and Rackwitz-Fiessler (EHL-RF) method base...

The corrosion of reinforcements induced by chloride has resulted to be one of the most frequent causes of their premature damage. Most corrosion sensors were designed to monitor corrosion state in concrete, such as Anode-Ladder-System and Corrowatch System, which are widely used to monitor chloride ingress in marine concrete. However, the monitoring principle of these corrosion sensors is based...

7 Corrosion of reinforcing steel in concrete can alter the interface between the steel and concrete and 8 thus affects the bond mechanism. This subsequently influences the behaviour of reinforced 9 concrete structures in terms of their safety and serviceability. The present paper attempts to 10 develop a numerical method that can simulate the behaviour of reinforced concrete walls subjected 11 ...

Cracking of the concrete cover due to corrosion is defined as the serviceability limit state of reinforced concrete structures. This study evaluated the influence of a mineral admixture i.e. nano wollastonite on corrosion performance and serviceability of reinforced concrete structures by performing an accelerated corrosion test on ten reinforced concrete beams under a sustained load. To do so,...

7 Corrosion of reinforcing steel in concrete can alter the interface between the steel and concrete and 8 thus affects the bond mechanism. This subsequently influences the behaviour of reinforced 9 concrete structures in terms of their safety and serviceability. The present paper attempts to 10 develop a numerical method that can simulate the behaviour of reinforced concrete walls subjected 11 ...

Epoxy coated reinforcement (ECR) has been used in Florida from the 1970s to 1990s but has been discontinued due to the observation of severe corrosion in some ECR bridges after short service times. Corrosion projections have been made in earlier investigations based on corrosion initiation and propagation concepts but did not consider the presence of structural cracks. The current research in p...

Shaft lining concrete itself has a certain degree of initial damage before being corroded by sulfate. In order to study the resistance of the concrete of the initial damage in different corrosion solution concentration of sulfate, samples of concrete without initial damage, loaded 50% ultimate load and loaded 70% ultimate load with initial damage concrete were selected and studied their corrosi...

Numerical simulation based on finite element method is conducted to predict the location of pitting corrosion in reinforced concrete. Simulation results show that it is feasible to predict corrosion monitoring based on ultrasonic guided wave in reinforced concrete, and wavelet analysis can be used for the extremely weak signal of guided waves due to energy leaking into concrete. The characteris...

FOREWORD Salt-induced reinforcing steel corrosion in concrete bridges has undoubtedly become a considerable economic burden to many State and local transportation agencies. Since the iron in the steel has a natural tendency to revert eventually to its most stable oxide state, this problem will, unfortunately, still be with us, but to a much lesser degree due to the use of various corrosion prot...

Organic corrosion inhibitor is one of lower cost technologies that limit the deterioration of concrete structures. The influence of a newly prepared organic corrosion inhibitor on the corrosion behavior of carbon steel in simulated concrete pore solution was investigated by polarization curves, electrochemical impedance spectroscopy, and so on. The effect of organic corrosion inhibitors on conc...