In this paper, after collecting the rock samples from eight mines and one high way slope, the tests for determination of dry density, Uniaxial Compressive Strength, tensile Strength (Brazilian Test), elastic modulus, Schmidt hammer rebound number have been done on samples. In addition, in order to calculating the mean size of rock grains, quartz content, hardness and abrasivity, a thin sections...

Due to their widespread availability, sandstones are commonly used as a natural stone for buildings, monuments and sculptures. In thecurrent study, nine sandstone samples from the Upper Red Formation (specified by the letters A, B, C, CG, S, S1, Sh, Tr and Min)were studied from a petrophysical point of view and their durability was evaluated. Then, their suitability as building stones wasassess...

In order to study the application of lime-fly ash loess in permafrost subgrade engineering, uniaxial compressive test, fast direct shearing test and permeability tests were carried out on lime-fly ash loess under different curing ages and freeze-thaw cycles. Uniaxial compressive strength of lime-fly ash loess increases slowly with the curing ages, and can reach 3.5 Mpa after the curing ages of ...

------------------------------------------------------Abstract---------------------------------------------------------Estimation of strength properties (uniaxial compressive and point load) from physical properties (density, porosity and rebound hardness) of shale rock type from Kogi State, Nigeria was investigated. The shale rock types were sampled and tested for their properties through in-s...

Nine rock types including Sandstone, Limestone, Siltstone, Dolomite and Marl collected from six different rock formations of the Salt Range area of Pakistan were tested to evaluate the correlations between the uniaxial compressive strength and the corresponding values of the point load index. Two hundred rock cores were drilled and used for the uniaxial compressive strength and point load index...

Original scientific paper To analyse the influence of joint angle, number and spacing on the strength and acoustic emission (AE) characteristics of rock mass, the uniaxial compression model of rock specimens was established using the micro particle flow PFC2D software platform. The intact rock parameters were determined via trial and error, joints with different angles, numbers and spacing were...

The effect of an electric field on the bending behavior of [001] oriented and poled relaxor Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 (PIN–PMN–PT) single crystals was measured using a four point bending apparatus with a longitudinal electric field applied to the bar during bending. The surface finish and electric field amplitude were observed to affect the bending strength. Polished surfaces imp...