Cryogenic CO2-assisted minimum quantity lubrication milling technology is a green processing with broad application prospects. Aiming at the problem of tool wear in cryogenic difficult-to-machine materials and influence relevant parameters on wear, this study used coated cemented carbide tools to perform experiments under conditions. The micro-morphology chip was observed, energy spectrum conta...

Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...

to assessment alfalfa cultivars research project this research has been fulfilled in 2011 at khouzestan agricultural and natural resource research center in southwest of ahwaz in khouzestan province (iran) by position 31º20′ n, 48º40′ e. at first section for evaluation wet forage yield cultivars such as “baghdadi”, “mesasersa”, “yazdi”, “bami”, “nikshahri”, “synthetic” (main factor) and two cut...

Wire electrical discharge machining (WEDM) is extensively used in machining of conductive materials when precision is of prime importance. Rough cutting operation in WEDM is treated as a challenging one because improvement of more than one machining performance measures viz. metal removal rate (MRR), surface finish (SF) and cutting width (kerf) are sought to obtain a precision work. Using Taguc...

The utilization of TiB2 particles reinforced aluminum (Al6063) metal matrix composite materials in many different engineering fields has undergone a tremendous increase. Accordingly, the need of accurate machining of composites has increased enormously; an attempt has been made to assess the factors influencing surface roughness and material removal rate on machining the composite. The orthogon...

An instantaneous rigid force model for prediction of cutting forces in ball-end milling of  sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...

Generating-line method, which is based on the generating process of spherical involute curve, is a new processing theory of cutting ideal spherical involute gears. Based on the principle of the new method, this paper expands the traditional geometrical relationship into the cutting geometry of generating-line method, and proposes the base-cone parameters with their formulas to provide necessary...

The objective of this paper is to propose a model for the occupation, by leaf-cutting ants, of an attractive area using a form of the diffusion-advection partial differential equation, in which the population dispersal is modeled using a fuzzy parameter. In the studied domain there is an attractive region, which can represent areas with an elevated concentration of palatable host-plants with be...