in recent years the aluminum matrix composites are gaining wide spread applications in automotive, aerospace, defense, sport and other industries. the reason for this is their exciting properties like high specific strength, stiffness, hardness, wear resistance, dimensional stability and designer flexibility. the present work reports on mechanical properties and microstructure analysis of al-si...

The mechanical response of a metal–matrix composite to dynamic shearing deformations has been measured, using a new design of the thin-walled tubular specimen for the torsional Kolsky bar experiment that allows working with these difficult-to-machine materials. The advantages of using the new specimen design are as follows: (i) the thickness of the thin wall along the axial direction is very un...

The hot deformation behavior and processing characteristics of AZ91 alloy and nano-SiCp/AZ91 composite were compared at temperature ranges of 523 K-673 K and strain rates of 0.001-1 s-1. Positive impact of SiC nanoparticles on pinning grain boundaries and inhibiting grain growth was not obvious when deformation temperature was below 623 K, but was remarkable when the temperature was above 623 K...

In this investigation ‚the fracture toughness of A356 containing15%SiC composite was studied. Al/SiC composites have been considered because of their mechanical and erosion properties .Low fracture toughness in Al/SiC as compared with Aluminium alloys is one of its disadvantage. In this study at first A356 alloy was melted in a smelting electrical furnace then poured into the mould. A356-15% Si...

The present study examined wear characteristics of A356/melon shell ash particulate composites. Dry-sliding the stainless steel ball against specimen disc revealed the abrasive wear behavior of the composites under loads of 2 and 5N. The composite showed lower wear rate of 2.182 × 10-4 mm3/Nm at 20 wt% reinforced material under load of 5N. Results showed that wear rate decreased significantly w...

Abstract In this study, filtration of aluminum alloy (Al) with different weight fractions SiC particles (SiCp) was investigated. Therefore, three filter materials 20 pores per inch (ppi) ceramic foam filters (CFF) were tested. A special three-chamber furan mold used for the casting trials to provide uniform filling and flow conditions process. Samples from sections gating system, as well filter...

In this study, SiCp particles were reinforced at volumetric ratios of 5%, 10%, 15% and 20% into the EN AW 5756 (AlMg3) metal matrix composite by using squeeze casting method. The squeezing process was carried out for 10 seconds under a pressure 80 MPa. changes in wear behaviors friction coefficients 5754/SiCp samples examined under1.0 N force, 5000 cycles with 0.04 m/s sliding speed. As result ...

Microstructural and mechanical characterization of 10 vol% SiC particles (SiCp) reinforced 6061 Al-based composite fabricated by powder thixoforming (PTF) was investigated in comparison with the PTF and permanent mold cast (PMC) 6061 monolithic alloys. The results reveal that the microstructure of the PMC alloy consists of coarse and equiaxed α dendrites and interdendritic net-like eutectic pha...

The paper attempts to study the machinability issues of aluminium-silicon carbide (Al-SiC) metal matrix composites (MMC) in turning using HSS cutting tool. SiCp-reinforced metal matrix composites (MMCs) containing SiC particles (5wt%-20wt %) of 400mesh size were prepared by powder metallurgy (P/M) route and used as work material for turning. Experiments were conducted at various cutting speeds ...