This paper presents an implementation of open loop and closed loop control of Quadratic boost converter using PID controller.  Quadratic boost converter consists of boost converter and fly back converter driven by a single switch. Quadratic boost converter QBC is designed especially for regulating the DC interface between various micro sources and dc-ac inverter to electricity grid. Quadratic b...

In this manuscript, the experimental setup was designed and fabricated for optimizing the parameters of a catalytic converter of INDICA V2 exhaust system. Three turbulence intensify devices, namely Swirl Venturi, Swirl Blades and Swirl Contour, were close-fitted before the catalytic converter. The heating element is embedded in its body and thermocouples are used for knowing the performance at ...

This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are  red...

This paper proposes a multi-stage power generation system suitable for renewable energy sources, which is composed of a DC-DC power converter and a three-phase inverter. The DC-DC power converter is a boost converter to convert the output voltage of the DC source into two voltage sources. The DC-DC converter has two switches operates like a continuous conduction mode. The input current of DC-DC...

In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...

in this article our objective is to obtain steady state characteristics of shunt, series, and separately excited dc motors coupled with a centrifugal water pump supplied through a step-up, step-down, and cuk converter from photovoltaic generator. we assume that there are no storage batteries and, of course, the system must operate on maximum utilization i.e. maximum water must be pumped. it is ...

the monolithic catalytic converter is still the main pollution control device for modern vehicles in order to reach the ever-increasing legislative demands for low emission standards. the catalytic converters require a large expansion from the exhaust pipe to the front face of the monolith. unfortunately, packaging constraints often do not permit the use of long diffusers. hence, flow separatio...