in this paper, the mean value of strain energy density criterion has been used to predict the critical fracture load in specimens with u-shaped notch under bending loads. an equation for calculation of averaged strain energy density in this zone has been presented. bending loads under mode i have been considered. two cases have been studied: 1) the control volume only includes the semicircular ...

We study theoretically light propagations at the zigzag edge of a honeycomb photonic crystal consisting of dielectric rods in air, analogous to graphene. Within the photonic band gap of the honeycomb photonic crystal, a unimodal edge state may exist with a sharp confinement of optical fields. Its dispersion can be tuned simply by adjusting the radius of the edge rods. For the edge rods with a g...

increasing patch edges in natural habitats, as a result of habitat fragmentation, are a major threat for wildlife populations, especially avifaunal communities. habitat edges provide different conditions compared to the core area which can directly or indirectly cause changes in species number, population and composition. this fact will demand a dissimilar management strategy. this study was co...

A new machining process model that explicitly includes the effects of the edge hone is presented. A force balance is conducted on the lower boundary of the deformation zone leading to a machining force model. The machining force components are an explicit function of the edge radius and shear angle. An increase in edge radius leads to not only increased ploughing forces but also an increase in ...

There are several parameters that have significant influence in metal forming process. One of the most important of them is friction coefficient. Friction can change the pattern of metal flow and the force needed for deformation. It is necessary to determine the friction coefficient to study the effect of friction on metal forming process. This study is concerned with numerical and experimental...

It is shown that manufacturing tolerances of the fiber parameters bend radius and numerical aperture (NA) significantly influence the fiber bend loss performance and spectral response of a fiber based edge filter. A theoretical model, validated by experimental results, is used to determine the changes in key spectral parameters for an edge filter, resulting from changes within their manufacturi...

Let P be a polyhedral domain occupying a convex volume. We prove that the size of a graded mesh of P with bounded vertex degree is within a factor O(H P ) of the size of any Delaunay mesh of P with bounded radius-edge ratio. The term HP depends on the geometry of P and it is likely a small constant when the boundaries of P are fine triangular meshes. There are several consequences. First, among...

This paper investigates the interaction between cutting tool edge radius and material separation due to ductile fracture based on Atkins’ model of machining. Atkins’ machining model considers the energy needed for material separation in addition to energies required for shearing at the primary shear zone and friction at the secondary shear zone. However, the effect of cutting tool edge radius, ...

A graph is radially maximal if its radius decreases after the addition of any edge of its complement. It is proved that any graph can be an induced subgraph of a regular radially maximal graph with a prescribed radius T 2: 3. For T 2: 4, k 2: 1, radially maximal graphs with radius T containing k cut-nodes are constructed.