A water vapor electrolysis cell utilizing sulfuric acid as the electrolyte has been shown to be capable of operating efficiently on the typical humidity of cabin air. Concentrated sulfuric acid can absorb enough water from a 50% relative humidity air stream at 75°F to permit an electrolysis cell to c&rate at a current density as high as 150 mA/cm2. . Sulfuric acid was examined for physical prop...

Abstract In order to limit the temporary overvoltage, method of series current limiting reactor in line is often used power grid overvoltage. The parameters reactance directly affect level 50Hz installation a changes positive and zero sequence impedance line, which has an impact on overvoltage line. Installing 500 kV Line’s studied by using electromagnetic transient calculation software EMTP. s...

During the switching on/off of shunt capacitor banks in substations, vacuum circuit breakers (VCBs) are required to switch off or to switch on the capacitive current. Therefore, the VCBs have to be operated under a harsh condition to ensure the reliability of the equipment. This study presents a complete comparison study of ordinary and phase-controlled VCBs on switching 10 kV shunt capacitor b...

A logarithmic term is applied to account for the charge transfer overvoltage with most empirical polarization curve fitting equations for polymer electrolyte membrane fuel cells. The logarithmic term applied with state-of-the-art fitting equations is proportional to the logarithm of the cell output current density. This provides good fitting characteristics with large current densities, but res...

Original scientific paper The increasing sensitivity of electronic devices widely used in low-voltage AC systems requires an appropriate protection against voltage and current surges. Protection of the equipment against the prospective surges is based on application of surge protection devices (SPDs). Most common situation, especially in residential buildings, is application of only one SPD at ...

Electron channeling effects can create measurable signal intensity variations in all product signals that result from the scattering of the electron beam within a crystalline specimen. Of particular interest to the X-ray microanalyst are any variations that occur within the characteristic X-ray signal that are not directly related to a specimen composition variation. Many studies have documente...