Sensitivity analysis of a power system against overvoltage was performed. The analysis took into account the origin of the overvoltage, the grounding resistance magnitude and overvoltage injection point. The IEEE 13 bus test feeder system was implemented in EMTP-ATP and lightning and switching overvoltages were applied. Three cases were evaluated: the first one, applying lightning overvoltage a...

This paper presents a time-sequential simulation technique incorporating the effects of interruptions and voltage sags in the reliability cost/worth evaluation of distribution systems equipped with different overvoltage protection types. The interruption and voltage sag data for different overvoltage protection schemes was obtained from long-term measurements performed at a 110/20 kV substation...

In this paper studies of overvoltage and capacitance measurements at silver cathodes in aqueous perchloric acid at room temperature are described. Capacitances were deduced from open-circuit potential decay measurements. The increase of overvoltage and the growth of the measured capacitances in the course of electrolysis are attributed to a growing pseudocapacitance component. This is anal...

Residential rooftop-mounted solar photovoltaic (PV) panels are being installed at an increasing rate, both in New Zealand and globally. There have been concerns over possible issues such as overvoltage and overcurrent. These PV systems are mostly connected at low voltage (LV). This study presents a case study of simulating the entire LV network from a single utility, comprising 10,558 11 kV–415...

With the application of the articulated phase insulator, and the speed of electric locomotive rising, it is inevitable for the electric locomotive to adopt the technology automatic passing through the electric phase separation. However, when the locomotive passes the electric phase separation, a variety of overvoltages will be generated, such as the cut-off overvoltage and the closing overvolta...

Frequent Switching of arc furnace in steel company causes a great effect on the insulation of arc furnace transformer winding which in turn may causes a shutdown of production for long periods of time. Therefore, it is necessary to study and analyze the causes of these outages and design an adequate protective device. In this paper the transient overvoltage resulted from vacuum circuit breaker ...

There are many reasons for over voltages in power system. The overvoltage causes number of effect in the power system. It may cause insulation failure of the equipments, malfunction of the equipments. Overvoltage can cause damage to components connected to the power supply and lead to insulation failure, damage to electronic components, heating, flashovers, etc. Over voltages occur in a system ...

500kV substation is especially important to the grid of our country, once it encounters lightning damage, the safety and reliability of the whole power system will be directly affected. As lightning intruding waves will cause overvoltage on electric equipments by intruding from the transmission line or straightly stroking the substation, which seriously influences the insulation level of equipm...

In recent years, with the rapid development of offshore wind turbines (WTs), the problem of lightning strikes has become more and more prominent. In order to reduce the failure rate caused by the transient overvoltage of lightning struck offshore WTs, the influencing factors and the response rules of transient overvoltage are analyzed. In this paper, a new integrated electromagnetic transient m...

The challenge of designing robust electronic circuitry often results in a design with a multitude of discrete protection components with associated cost, design time, and space additions. This article discusses fault protected switch architecture, along with the performance benefits and other advantages it offers vs. traditional discrete protection solutions. A new novel switch architecture and...