As a service to the bridge design profession, Bethlehem Steel has conducted hundreds of studies of steel plate girder bridges using its Preliminary Bridge Girder Optimization Program. The program is unique because it optimizes plate girder designs on the basis of least cost, not least weight. An evaluation of many study results leads to a number of guidelines which are offered in this paper. Wh...

The concept of spraying thick layer of polymer material onto metal plate has recently received considerable interest in many civilian and military applications. There are numerous analytical and numerical solutions for single thin plates (membrane) made of either a steel or an elastomer. However, solutions for composite plate made of both of the above constituents are lacking. The objective of ...

Godrej Security Solution Division has developed bullet resistant solutions like Bullet resistant doors, Mantraps, Bullet resistant screening for banks, and bullet resistant cabins etc which are designed as per the requirements mentioned in various standards like National institute of Justice (NIJ), Underwriters Laboratory (UL), etc. These agencies have established the performance criteria and c...

Large diameter steel line pipes are generally produced by cold deforming hot rolled or thermomechanically controlled rolled (TMCR) plate by the three-stage 'UOE' process. Pipe strength has been found to increase or decrease relative to the plate, depending on the steel grade and plate processing history. The strength increase is due to work hardening whereas any decrease in strength arises from...

the effect of welding residual stresses that was created in thin infill plate of steel plate shear wall system during constructional processes was studied in this research. residual stresses in a welded structure is the result of the non-uniform expansion and contraction and plastic deformation of the weld and surrounding base metal due to heating and cooling cycle, during welding process, this...

This paper describes an alternative finite element model that would yield more accurate results in the prediction of the behavior of Profiled Steel Sheet Dry Board (PSSDB) folded plate structures, which can be considered as an improvement of an earlier proposed model. The PSSDB folded plate structures are being proposed as an alternative to traditional forms of roof construction.The PSSDB syste...

Combining the advantages of basalt fiber-reinforced polymer (BFRP) material and steel material, a novel BFRP-steel composite plate (BSP) is proposed, where a steel plate is sandwiched between two outer BFRP laminates. The main purpose of this research is to investigate the mechanical behavior of the proposed BSP under uniaxial tension and cyclic tension. Four groups of BSP specimens with four d...

Calcium acetate, which can be used in concrete to shorten the construction period and to improve productivity, was manufactured using limestone sludge and acetic acid. Calcium acetate contains a carboxyl group, and it can provide anticorrosive properties by forming a complex with the steel surface. We evaluated the basic performance of a carboxylic early-strength agent produced from industrial ...

This article proposes a novel method for analyzing residual stress and deformation in butt welding on 6 mm SUS304 stainless steel plates, using MSC.MARC, a commercial finite element method software, to find the best location for jig fixtures that will minimize welding deformation. Simulation and experimental studies show that a distance of 100 mm between the jig center and the welding bead cent...

In tall buildings the reinforced concrete (RC) shear wall is one of the predominant structural components used to resist lateral loads induced by earthquakes around the world. Previous research demonstrated that shear walls displayed a sudden loss in lateral capacity due to the wall corner and web crushing in the plastic zone. In addition, it was found that large shear distortions in shear wall...