Materials with a hexagonal close-packed (hcp) crystal structure such as Mg, Ti and Zr are being used in the transportation, aerospace and nuclear industry, respectively. Material strength and formability are critical qualities for shaping these materials into parts and a pervasive deformation mechanism that significantly affects their formability is deformation twinning. The interaction between...

Replacement by aluminum for the closure panels is one of the common methods for lightening car body. However the application used to be limited into shallow drawing parts like hood because of its low stamping formability. As a solution to cover the low stamping formability of aluminum, Blow forming technology of aluminum which is one of the superplastic forming technologies has been researched ...

Cold rolling with subsequent annealing can be used to produce the recrystallized structure in high entropy alloys (HEAs). The Al0.25CoCrFeNi HEAs rolled to different final thickness (230, 400, 540, 800, 1000, 1500 μm) are prepared to investigate their microstructure evolutions and mechanical behaviors after annealing. Only the single face-centered cubic phase was obtained after cold rolling and...

A modified strain-induced melting activation (SIMA) process is shown to improve high-temperature formability. The microstructural characteristics of the spheroidized grains of SIMA-processed alloys affect high-temperature formability. The effects of hot extrusion parameters and chemical composition on the evolution of spheroidized grains were investigated using several 6xxx series aluminum allo...

Low qualified rate and inferior quality frequently occurring in the general deep drawing process of a certain box-shaped part, now use hydroforming to optimize forming process, in order to study the effect of hydroforming for improving the quality and formability, purposed five process schemes: general deep drawing, active hydroforming, passive hydroforming, general deep drawing combined with a...

The purpose of introducing ultrasonic vibrations in the tube hydroforming process is to create more formability by obtaining a lower corner radius, improve thickness distribution of the wall and provide good tribological conditions at the tube and the die interface. Vibrations imposed on the die create alternating gaps which improve the formability in the tube hydroforming process in the presen...

The use of TWB has been developed in automotive industries because of it’s advantages such as reduction in weight, cost and fuel economy of vehicles. The main objective of the peresent work is to study the effects of weld zone, diffrence in surface coating and thickness ratio on the formability of TWB composed of AISI 304, SPCC and IF steel sheets. It was found that the narrow weld zone has lit...

In this paper, the mechanism of improvement of formability in pulsating hydroforming of T-shape tubes is investigated by the finite element simulation and experiment. It is shown that local thinning was prevented by oscillating the internal pressure, because the protrusion is formed gradually by the prevention of sharp bulging. In the hydroforming, for the pulsating pressure, several steps occu...

The forming limit diagram (FLD) is probably the most common representation of sheet metal formability and can be defined as the locus of the principal planar strains where failure is most likely to occur. Low carbon steel sheets have many applications in industries, especially in automotive parts, therefore it is necessary to study the formability of these steel sheets. In this paper, FLDs, wer...

The use of TWB has been developed in automotive industries because of it’s advantages such as reduction in weight, cost and fuel economy of vehicles. The main objective of the peresent work is to study the effects of weld zone, diffrence in surface coating and thickness ratio on the formability of TWB composed of AISI 304, SPCC and IF steel sheets. It was found that the narrow weld zone has lit...