Thermodynamic analysis of a steady state flow and heat transfer of an Oldroyd 8-constant fluid with effect of heat source, velocity slip and buoyancy force under tranverse a magnetic field is is carried out in this paper. The model for momentum and energy balance is tackled numerically using Method of Weighted Residual (MWR). Partition method is used to minimize the associated residuals. The re...

This paper reports a plenary thermodynamic model of a novel solar system for water heating in buildings. Energy and exergy analyses are used to characterize the exergy destruction rate in any component and calculate system overall efficiency. The system consists of a solar evaporator, a heat exchanger to produce hot water, and an auxiliary pump. A computer simulation program using EES software ...

Transient thermal field in laser surface hardening treatment of medium carbon steel was analyzed by employing both three-dimensional analytical model and finite element model. In finite element model the laser beam was considered as a moving plane heat flux to establish the temperature rise distribution in the work-piece, while in analytical model laser beam was considered as an internal heat s...

The Sun encompasses planet Earth, supplies the heat that warms it, and even shakes it. The United Nation’s Intergovernmental Panel on Climate Change (IPCC) assumed that solar influence on Earth’s climate is limited to changes in solar irradiance and adopted the consensus opinion of a hydrogen-filled Sun—the Standard Solar Model (SSM). They did not consider the alternative solar model and instea...

Received: 12 November 2002 / Accepted: 22 May 2003 / Published: 31 December 2003 __________________________________________________________________________________ Abstract: Based on a model of a two-heat-reservoir heat engine with a finite high-temperature source and bypass heat leak, the optimal configuration of the cycle is found for the fixed cycle period with another linear heat transfer l...

The present paper is devoted to the determination of displacement, stresses and temperature from three dimensional anisotropic half spaces due to presence of heat source. The normal mode analysis technique has been used to the basic equations of motion and generalized heat conduction equation proposed by Green-Naghdi model-II [1]. The resulting equation are written in the form of a vector –matr...

In the present study, the conjugate turbulent free convection with the thermal surface radiation in a rectangular enclosure bounded by walls with different thermophysical characteristics in the presence of a local heater is numerically studied. The effects of surface emissivity and wall materials on the air flow and the heat transfer characteristics are the main focus of the present investigati...

The object of the present paper is to study temperature distribution and thermal stresses of a functionally graded thick hollow cylinder with temperature dependent material properties. All the material properties except Poisson’s ratio are assumed to be dependent on temperature. The nonlinear heat conduction with temperature dependent thermal conductivity and specific heat capacity is reduced t...

conceptual design of a waste heat recovery cycle is carried out in attempt to enhance the thermal efficiency of a steam power plant. in the recovery system, super-critical an co2 is employed as the working fluid operating in a brayton cycle. low grade heat rejected by the flue gases through the stack is used as the primary heat source, while a secondary heat exchanger utilizes the hot gases lea...

Abstract. This paper focuses on the contribution of the second order corrector in periodic homogenization applied to a conductive-radiative heat transfer problem. Especially, for a heat conduction problem in a periodically perforated domain with a non-local boundary condition modelling the radiative heat transfer, if this model contains an oscillating thermal source and a thermal exchange with ...