In this paper, an analytical method for noncircular shape extrusion is presented. Using this method, non-linear deformation field can be described with Hermit cubic spline which is prescribed by the boundary conditions of the die at its entryand exit. The upper bound method has been used to obtain optimum coefficient of the tangential boundary conditions. The results show that the optimum tange...

rectangular waveguide (wr) is one of the earliest types of transmission lines. rectangular waveguide can be produced by hot extrusion process. in this paper, the hot extrusion process of cuzn5 rectangular waveguide was investigated by finite element method (fem). in addition, genetic algorithm method (ga) was used to optimize the die geometry and process conditions to achieve the lowest magnitu...

Deep drawing process is one of the most applicable methods in producing industrial parts. In this process, the initial blank deforms to final product using a rigid punch and die. In this investigation, the effect of deep drawing process parameters of brass/steel laminated sheet composites on required forming force has been investigated. The process simulated using finite element method (FEM) an...

there are many parameters that affect the sheet hydroforming process such as fluid pressure, material properties, interfacial friction between blank and tool surfaces, etc. in this paper, a fem-based taguchi method is used to determine the effects of forming parameters on the quality of part formability in the process of hydrodynamic deep drawing assisted by radial pressure. four important form...

Die corner filling is very important in tube hydroforming process. Definition of the internal pressure path is a key factor in improving the corner filling.  However, the factors that cause improvement of corner filling are still unclear. In this paper, effect of bilinear pressure path on corner filling in hydroforming of tube in box-shape die is studied using both finite element simulation and...

In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...

The aim of the present study is to determine the feasibility of making a rectangular twist waveguide used to rotate electromagnetic waves. For this purpose, the process of fabricating an aluminum rectangular twist waveguide was simulated by making use of finite element method and Deform software. The optimum length and angle of the twist die for manufacturing a twist waveguide with inner cross ...

Micro-stamping process is one of the most cost-effective methods to manufacture metallic bipolar plates (BPPs). This research investigates the forming of titanium thin sheet as a potential candidate for BPPs in proton exchange membrane fuel cell (PEMFC). In this regard, the process was first simulated using finite element (FE) code Abaqus. Afterward, experimental tests were implemented and the ...

the main objective of an extrusion die is flow balancing as an unbalanced flow causes a distorted product together with residual stress. in this paper a strategy is presented for flow balancing a u-shaped profile with different wall thicknesses. for this purpose, a choker bar is provided at thicker wall to locally restrict excessive flow passing through the thicker section. for optimal design s...