Orthodontic tooth movement can be regarded as teeth sliding on a wire like pearls on a string, the force being supplied by springs or elastics. The movement implies friction between wire and bracket, taking up part of the force and leaving an uncontrolled amount to act on the teeth. The friction is likely to depend on bracket construction and wire material. Therefore, in this investigation the ...

in this study, the effects of linear and rotational speed of the friction stir welding tool was investigated on the heat generation and distribution at surface and inside of workpiece, material flow and geometry of the welding area of poly methyl methacrylate (pmma) workpiece. the commercial cfd fluent 6.4 software was used to simulation of the process with computational fluid dynamic technique...

This work revealed the results of comparative surveys of the impact of formed surface layer TiN and CrN and two component surfaces layer TiN-steel and CrN-steel. The slide couple worked in conditions of lubricating the friction area with Lotos Syntetyk 5W/40 and Castrol GTX Magnatec 5W/40 engine oils. In the friction couple the counter sample was made from CuPb30 bearing alloy. The tribological...

In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...

The importance of friction and wear control cannot be over emphasized for economic reasons and longterm reliability. The savings can be substantial, and these savings can be obtained without the deployment of investment. Tribology is crucial to modern machinery which uses sliding and rolling surfaces. This article describes the tribological behavior analysis for the conventional materials i.e. ...

In this paper, the results of experiments conducted to investigate the friction coefficient existing at a brass-steel interface are presented. The research discussed here is the second of a two-part study on the size effects in friction conditions that exist during microextrusion. In the regime of dimensions of the order of a few hundred microns, these size effects tend to play a significant ro...