To avoid the complexities associated with the droplet/vapor transport and nonuniform evaporation processes, a fundamental investigation of liquid fuel combustion in idealized configurations is very useful. An experimental–computational investigation of prevaporized n-heptane nonpremixed and partially premixed flames established in a counterflow burner is described. There is a general agreement ...

This dissertation: (i) develops a novel numerical method for DNS/LES of compressible, turbulent reacting flows, (ii) performs several validation simulations, (iii) studies auto–ignition of a hydrogen vortex ring in air and (iv) studies a hydrogen/air turbulent diffusion flame. The numerical method is spatially non-dissipative, implicit and applicable over a range of Mach numbers. The compressib...

This paper describes a new method of sensor failure detection, isolation, and accommodation using a neural network approach. In a propulsion system such as the Space Shuttle Main Engine, the dynamics are usually very complicated and sometimes not well known. However, the number of variables measured is usually much higher than the order of the system. This built-in redundancy of the sensors can...

Homogeneous Charge Compression Ignition (HCCI) combustion is a pioneer method of combustion in which pre-mixed fuel and oxidizer (typically air) are compressed to the point of auto-ignition. HCCI engines can operate with most alternative fuels, especially, dimethyl ether (DME) which has been tested as a possible diesel fuel due to its simultaneously low NOx and PM emissions. In this paper a ...

simulation of metallurgical processes has been the subject of intense research due to the reduced number of experiments required for controlling the process as well as time and energy savings it allows. in gas carburizing of steel parts, the amount of carbon at the surface of carburized parts is the most important specification of the process in terms of achieving the desired metallurgical prop...

The use of hydrocarbons is very appealing for the realization of high energy density power sources, so long as the fuel can be stored in the liquid phase. As a result, except for the most volatile hydrocarbons, a miniaturized combustor must rely on a good design of the fuel atomizer, which should yield small, rapidly evaporating droplets to generate the fuel vapor promptly, mix it with the oxid...

A fire on the Mir space station in 1997 threatened the spacecraft and its crew of six [1]. The fire involved an oxygen jet leaking from a lithium–perchlorate oxygen generator. The fire involved three factors not normally encountered in terrestrial fires: enhanced oxygen, inverse flames (in that the oxidizer is surrounded by fuel), and microgravity. The present work examines some effects of thes...

Regenerative Thermal Oxidizer (RTO) is one of the best solutions for removal of Volatile Organic Compounds (VOC) from industrial processes. In the RTO, VOC in a raw gas are usually decomposed at 950-1300 K and the combustion heat of VOC is recovered by regenerative heat exchangers charged with ceramic honeycombs. The optimization of the treatment of VOC leads to the reduction of fuel addition t...