there have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. one set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. different lengths of curved struts are fabricated so as to cover a practical ...

The failure of an orthopaedic implant can be initiated by residual strain inherent to the hydroxyapatite coating (HAC). Knowledge of the through-thickness residual strain profile in the thermally sprayed hydroxyapatite coating/substrate system is therefore important in the development of a new generation of orthopaedic implants. As the coating microstructure is complex, non-destructive characte...

In this paper, low cycle fatigue life of CK45 steel and SS316 stainless steel under strain-controlled loading are experimentally investigated. In addition, the impact of mean strain and strain amplitude on the fatigue life and cyclic behavior of the materials are studied. Furthermore, it is attempted to predict fatigue life using energy and SWT damage parameters. The experimental results demons...

the dynamic behavior of three high manganese steels with very different stacking faultenergy (sfe) values (4-30 mj/m2) were studied using high strain rate torsional tests. the hotrolledmicrostructure of the steel with the lowest sfe of 4 mj/m2 consisted of a duplex mixture ofaustenite and ε-martensite, but those of the other two steels were fully austenitic. the deformedmicrostructures were stu...

Shot peening is a process in which a stream of shot is blasted against an engineering component to generate a high compressive residual stress regime at the surface of the component. This paper describes a 3D finite element dynamic analysis of single shot impacting on a metallic component. The model is first validated against a published numerical study. A parametric study is conducted to inves...

Direct stamping of functional materials has been developed for cost-effective and process-effective manufacturing of nano/micro patterns. However, there remain several challenging issues like the perfect removal of the residual layer and realization of high aspect ratio. We have demonstrated facile fabrication of flexible strain sensors that have microscale thick interdigitated capacitors with ...

a new method for determination of residual stresses in the bottom layers of laminated composites is developed. in this method the residual stresses are determined by performing a consecutive drilling of laminated composites in the center of the rosette and recording the strains after drilling each layer. the depth of the hole in each step is equal to the thickness of each layer and the maximum ...