Magnesium is the lightest of all metals used as the basis for constructional alloys. It is this property which entices automobile manufacturers to replace denser materials, not only steels, cast irons and copper base alloys but even aluminium alloys by magnesium based alloys. The requirement to reduce the weight of car components as a result in part of the introduction of legislation limiting e...

Investigation of the tensile and fatigue properties of cast magnesium alloys, created by the heated mold continuous casting process (HMC), was conducted. The mechanical properties of the Mg-HMC alloys were overall higher than those for the Mg alloys, made by the conventional gravity casting process (GC), and especially excellent mechanical properties were obtained for the Mg97Y2Zn1-HMC alloy. T...

The aim of this study was to evaluate the influence of microstructure and composition of basic alloys on their microshear bond strength (µSBS) to resin luting cement. The alloys used were: Supreme Cast-V (SC), Tilite Star (TS), Wiron 99 (W9), VeraBond II (VBII), VeraBond (VB), Remanium (RM) and IPS d.SIGN 30 (IPS). Five wax patterns (13 mm in diameter and 4mm height) were invested, and cast in ...

A literature review on methods to consider mechanical behaviour of cast aluminium alloys in finite element method (FEM) simulations of cast aluminium components has been performed. The mechanical behaviour is related to several microstructural parameters achieved during the casting process. Three different methods to consider these microstructural parameters are introduced. One method predicts ...

Purpose: The paper presents results of the research connected with the development of new approach based on the neural network to predict chemical composition and cooling rate for the mechanical properties of the Mg-Al-Zn cast alloys. The independent variables on the model are chemical composition of Mg-Al-Zn cast alloys and cooling rate. The dependent parameters are hardness, ultimate compress...

Al-5Mg-0.8Mn alloys (AA5083) with various iron and silicon contents were cast under near-rapid cooling and rolled into sheets. The aim was to study the feasibility of minimizing the deteriorating level of the harmful Fe-rich phases on the mechanical properties through refining the intermetallics by significantly increasing the casting rate. The results showed that the size and density of the in...

Dental alloys for direct metal laser sintering (DMLS) are available on the market today, but there is little scientific evidence reported on their characteristics. One of them is the release of ions, as an indicator of the corrosion characteristics of a dental alloy. Within this research, the difference in the elution of metals from DMLS and cast (CM) samples of Co-Cr-Mo dental alloy in saliva-...

Ultrasound treatment of liquid aluminum alloys is known to improve mechanical properties of castings. Aluminum foundry alloys are frequently used for production of parts that undergo severe cavitation erosion phenomena during service. In this paper, the effect of the ultrasound treatment on cavitation erosion resistance of AlSi7 alloy was assessed and compared to that of conventionally cast sam...

The heating parts of thermogravimetry curves performed for cast alloys in air at high temperatures were analysed, after correction from the effects of air buoyancy variation, to characterize the transient oxidation before reaching the targeted temperature for the isothermal stage usually applied thereafter. This was done here for three binary M-30Cr alloys, six ternary M-30Cr-0.4 and 0.8%C allo...

Nowadays, the technology intends to use materials such as magnesium alloys due to their high strength to weight ratio in engine components. As usual, engine cylinder heads and blocks has made of various types of cast irons and aluminum alloys. However, magnesium alloys has physical and mechanical properties near to aluminum alloys and reduce the weight up to 40 percents. In this article, a new ...